B-Line Eaton series imperial cable tray and ladder, 6" Height, 49.6875" Length, 30" Width, Series 2-5 horizontal bend, Aluminum, 45° Angle, 48" Radius

The 6A-30-45HB48 turns 45 degrees on a 48 inch radius, measured to the inside of the turn, and the fitting itself measures 49.6875 inches along its length dimension. Lay out your hangers and wall clearance for that sweep before you commit the straight runs on either side. The large radius is what keeps the bend gentle enough for the cable bend radius on heavy power feeders.

Aluminum. That's the usual call for exterior, wash-down, and corrosive process areas where a painted or plain steel tray would need coating maintenance, and it keeps the piece light for overhead work at 17.104 lb. If your spec calls for hot dip galvanized steel tray, don't mix this in, the fittings and straights should be the same material system.

It's a Series 2 through 5 horizontal bend for B-Line's imperial cable tray and ladder line, so it drops into the same ladder-type run as the matching straight sections. Order it by part number 6A-30-45HB48 to keep the rail profile and splice holes matched to your existing sections.

The fitting weighs 17.104 lb, so it's a one or two man lift depending on how you are rigging it, but it's awkward more than heavy at 30 inches wide. Rig your trapeze hangers on both legs of the turn before you set it.

It carries CE marking. That's the only marking held on record for this fitting, so if your submittal needs anything beyond that, verify against the manufacturer's series data before you submit.