B-Line SB86086S066SL Eaton series open frame racks, 60.375" height, 10.8125" length, 6" width, Aluminum, RCM rack mounted vertical cable manager, Direct pdu mounting, High density plastic finger, Silver powder coat

The SB86086S066SL is 60.375 inches tall, so it covers roughly the panel space of a 34U section. On a 45U (about 78 inch) rack it will not run the full height, which leaves the top of the rack without finger coverage. For a full-height run on a taller frame you would stack or pair managers, or choose a taller RCM length. Check the usable mounting height on your frame against the 60.375 inch dimension before ordering.

Plan for 6 inches of width and 10.8125 inches of depth. That 6 inch channel is the space it occupies alongside the rack uprights, so in a row of open frame racks you need 6 inches of clear floor and aisle allowance per manager between bays. The 10.8125 inch depth sits it roughly in line with a standard open frame rack footprint rather than projecting well past it.

Yes. Direct PDU mounting is built into this RCM vertical manager, so a vertical rack PDU attaches into the channel rather than eating a rack unit on the front rails or needing a separate PDU bracket. That is the main reason to pick this version over a plain finger duct.

It does. The RCM channel provides unrestricted front and rear cable routing, so patch cords on the front side and switch or server tails on the back side both drop into the same vertical path. The high density plastic fingers hold bundles in place as they exit toward each panel.

Vertical managers like this RCM handle the trunk, the bundle running the height of the rack between patch panels and active gear, and it is built for routing high density cabling. Horizontal managers only handle slack and turn at a single panel. In a dense patch field you use both: horizontal 1U or 2U between panels for service loops, vertical channel for the run up and down the frame. If you only buy one, the vertical channel is what keeps bundles off the rails.

UL certification is carried on this Eaton B-Line RCM vertical cable manager, which is what most facility and institutional specs ask for on rack accessories. Beyond that, no other agency listing applies to it.

At 13.4 lb it is a one person lift, though the 60.375 inch length is awkward on a ladder, so a second set of hands makes alignment on the rack uprights easier. Fasten from the bottom mounting points upward to hold it plumb.

Order by manufacturer part number SB86086S066SL. That number pins the whole configuration: 60.375 inch height, 6 inch width, 10.8125 inch depth, aluminum with silver powder coat, direct PDU mounting. There are no finish or size options to specify separately on this part.