B-Line SB86086S090SL Eaton series open frame racks, 84.875" height, 10.8125" length, 6" width, Aluminum, RCM rack mounted vertical cable manager, Direct pdu mounting, High density plastic finger, Silver powder coat

At 84.875 inches tall, the SB86086S090SL runs essentially the full height of a standard 7-foot (84 inch) open frame rack, so plan on it spanning the entire upright rather than a partial section. It is 6 inches wide and 10.8125 inches deep, so allow that 6 inch footprint alongside the rack rails and confirm your aisle leaves room for the 10.8125 inch depth.

Yes. The SB86086S090SL is built for direct PDU mounting, so a vertical rack PDU attaches to the manager itself instead of eating a rack unit or a separate bracket in the frame. That is the main reason to pick this version over a plain finger duct.

It does. The RCM rack mounted vertical cable manager is designed with unrestricted front and rear cable routing, so you can drop patch cords on the equipment side and power or trunk cabling on the back side of the same 6 inch channel.

High density is what it was made for. The channel uses high density plastic fingers and Eaton specifies it for routing high density cabling, so it handles a fully loaded switch stack rather than a few drops.

No, this one is silver. The SB86086S090SL is finished in silver powder coat aluminum with black plastic components, so on an all-black rack line it will read as a contrast rather than a match. If finish consistency matters across a row of cabinets, specify a black-finish version of the same RCM manager instead.

Order it as Eaton B-Line SB86086S090SL. That number is the silver powder coat, 84.875 inch tall, 6 inch wide RCM vertical manager with direct PDU mounting. Width and finish are baked into the part number, so if you need a wider channel or a different color it is a different SB number.