B-Line Eaton series strut fittings and accessories, 5.43" Height, 20" Length, 1.62" Width, 2.75lbs, Steel, Right bracing slotted bracket, Thickness 1/

It is a right bracing slotted bracket for strut framing, used to brace or angle off a strut run where a diagonal member has to tie back to the structure or to another channel. Steel construction, 1/4 inch material thickness, and 20 inches long, so it carries a brace across a meaningful span rather than acting as a short connector plate.

This is the right bracing bracket. Bracing angles are handed, so if your layout runs braces off both sides of a strut trapeze or both directions from a column, you will need the matching left-hand bracket as well. Count your braces by direction before ordering rather than assuming one part covers both.

The bracket measures 20 inches in length, 5.43 inches in height, and 1.62 inches in width, and weighs 2.75 lb. The 1.62 inch width is what lets it sit against standard 1-5/8 inch strut face; the 20 inch length is the reach you get for the diagonal.

DURA GREEN is Eaton B-Line's coated finish for corrosion resistance, and it is the finish this bracket ships in. Match it to the rest of your run: if your strut and fittings are plain electro-zinc or hot dip galvanized, mixing in a coated green fitting will be visually obvious, and for heavy corrosive or wash-down areas most specs call out hot dip galvanized or stainless instead.

No listing or certification applies to this bracket; it is a plain steel structural fitting. If your submittal needs a listed assembly, that requirement is usually satisfied at the system level through the strut manufacturer's load tables rather than on the individual bracket.