B-Line Eaton series strut fittings and accessories, 3.93" Height, 14" Length, 1.62" Width, 1.62lbs, Steel, Right bracing slotted bracket, Thickness 1/

It's a right-hand bracing slotted bracket for Eaton B-Line strut fittings, used to brace or angle a strut run where the leg needs to run to the right. The steel body is 14 inches long with a 3.93 inch height and 1.62 inch width, so it spans a fair distance off the main strut member. Because it's specifically the right-bracing version, a left-hand brace is a separate part; order by the direction of the leg as you face the run.

There are 6 holes total: one 7/16 inch diameter hole plus four 1 inch long by 13/32 inch slots. A 13/32 inch slot and a 7/16 inch hole both clear a 3/8 inch bolt, which is the usual strut hardware size, and the slots give you some adjustment along their 1 inch length when you're lining up to an existing strut.

If the brace leg runs to the left of the strut, yes. B179SHRGRN is the right bracing slotted bracket, and the hole and slot layout is handed, so it will not mirror to the opposite side and still land on the strut holes. Confirm the direction at the opening before you order, or order both hands when you're bracing a run from each side.

1/4 inch steel. That's a plate-thickness brace rather than a light formed bracket, and the whole piece weighs 1.62 pounds. Bolts and channel nuts are not part of the bracket, so add strut hardware separately.

The bracket ships in Eaton's DURA GREEN finish over steel, a coated finish used on B-Line strut fittings for added corrosion protection compared with plain or pre-galvanized steel. It's the finish to match if the rest of your strut run is already DURA GREEN, since mixing coatings on the same run is the usual reason a green fitting looks out of place.