B-Line Eaton series strut pipe clamps and accessories, .06" height, 2.222" length, 1.25" width, 400 lbs, Steel, Pre-assembled combination recess hex h

It ships with a pre-assembled combination recess hex head screw, so the fastener is already in the clamp when it comes out of the box. An installer can drive it with either a hex driver or a recess bit, which matters overhead where you are working one-handed. Anything else you need is channel-side: the strut itself and whatever anchoring the structure calls for.

Steel with a yellow zinc chromate finish. That is a plated indoor and protected-location finish, typical for electrical and mechanical rooms, above ceilings and interior pipe runs. For continuously wet, exterior or corrosive service you want a hot dip galvanized or stainless clamp instead of the yellow zinc version.

Order Eaton B-Line part number B2001PAYZN. The PA in the number is the pre-assembled hardware and the YZN is the yellow zinc chromate finish, which is the pair of details distributors most often get wrong when substituting within the B2001 clamp family.

It measures .06 x 2.222 x 1.25 inches (height, length/depth, width as published) and weighs .1 lb. The light weight and small footprint mean a box of them adds almost nothing to a material order, and the 2.222 inch length is what you check against your channel spacing when clamps sit close together on a single run.

Certifications on the B2001PAYZN are noted as not applicable, so treat it as a standard steel strut mounting component rather than a listed assembly. If your submittal package requires a third-party listing on the support hardware, have the engineer confirm what the spec actually demands before you order.