B-Line B2011SS6 Eaton series strut pipe clamps and accessories, .074" height, 3.351" length, 1.25" width, Steel, Includes combination recess hex head machine screw, Pipe or conduit clamps, Stainless steel type 316

The B2011SS6 is the Type 316 stainless steel version of the B2011 strut pipe clamp. Type 316 is the grade to specify for coastal, wash-down, water treatment, and chemical exposure, where plain or electro-galvanized steel clamps will bloom rust. Note the spec table lists the material simply as Steel, which is the base family, while the part designation SS6 is what identifies the 316 stainless.

The mounting screw is in the box. Each B2011SS6 clamp includes a combination recess hex head machine screw, so it threads straight into the strut channel nut or spring nut without a separate fastener order. You still need the channel nut and the strut itself.

Yes. The B2011SS6 is a strut pipe clamp, meant to fasten a run of pipe or conduit to strut channel rather than directly to a wall or deck. The supplied hex head machine screw lands in a channel nut inside the strut. If you are fastening to concrete or steel with no channel present, you want a one-hole or two-hole strap instead, not this clamp.

It measures .074 x 3.351 x 1.25 inches (height, length, width as published) and weighs .2 lb each. The .074 inch figure is the strap stock thickness, so the clamp adds almost nothing to the standoff off the strut face, which matters when you are stacking runs tight to a wall or ceiling.

Yes, keep the whole assembly in the same family. Pairing a 316 stainless clamp with galvanized strut and a plated nut puts dissimilar metals in permanent contact in a wet location, which is where galvanic corrosion starts. If you spec the B2011SS6 for its 316 corrosion resistance, spec 316 stainless strut and 316 channel nuts with it.

Order by manufacturer part number B2011SS6 from Eaton B-Line. That single designation covers the clamp and its combination recess hex head machine screw, so a repeat order matches what is already on the racks without needing a finish or hardware suffix.

No listing or certification applies to the B2011SS6; the certification field reads Not Applicable. It is a mechanical support component, catalogued for electrical conduit and pipe support. If your specification calls out a listed support assembly, that requirement will sit on the strut system, not on the individual clamp.