B-Line Eaton series strut pipe clamps and accessories, .0994" height, 6.281" length, 1.25" width, 1000 lbs, Steel, Include combination recess hex head

Hardware is included. The B2054ZN ships with a combination recess hex head machine screw, and the bolt size is 5/8"-18. You still need your own strut nut or channel nut to land it in the strut, and the strut itself.

It's an O.D. pipe conduit clamp, so it is selected off the actual outside diameter of what you are clamping, not the nominal trade size. Measure the outside diameter of the conduit or pipe with a tape or caliper and match to that. This matters most on copper tube and on pipe types where nominal size and O.D. do not line up.

The clamp is steel with an electro-plated zinc finish. Electro-zinc is a light coating suited to dry, indoor, protected runs: mechanical rooms, ceilings, interior plant. For exterior exposure, washdown areas, or corrosive process environments, specify a hot dip galvanized or stainless clamp instead, since electro-zinc will surface rust once it is wet regularly.

Beyond the clamp, you need strut channel, a channel nut with spring for each clamp, and anchors or beam clamps to attach the strut to the structure. The machine screw that fastens the clamp halves is supplied with the B2054ZN, so that is the one piece you do not have to source. Order one clamp per support point along the run.

The B2054ZN measures 6.281 in length/depth, 1.25 in width, and .0994 in height, and it weighs .61 lb. The 1.25 in width is the number to check against your strut channel face and against the spacing of adjacent clamps if you are ganging several runs on one piece of strut.

For part identification on a submittal, order by manufacturer part number B2054ZN, Eaton B-Line series, steel with electro-plated zinc, 1000 lbs capacity, 5/8"-18 bolt. Support spacing and material for conduit runs is governed by the NEC article for the raceway type you are installing, and your engineer's hanger schedule will call the spacing.