B-Line Eaton series Type 1 junction boxes, 12" height, 6" length, 10" width, 1, Screw cover, SCGV enclosure, Surface mounted, Small single door, 5 kn

No. The 12106 SCGV carries a NEMA Type 1 rating, which is indoor, dry-location use only, for protection against incidental contact and falling dirt. It is not sealed against water, dust, oil, or corrosive washdown. For outdoor, damp, or hose-down locations you need a gasketed enclosure rated Type 3R, 4, or 4X instead.

12 inches high, 10 inches wide, and 6 inches deep, so it needs about a 12 by 10 footprint on the wall plus clearance to pull the cover. It weighs 8.7 lb empty, light enough to hang on one person's mounting.

Knockouts are already provided: 5 on each side, 5 on the top, and 5 on the bottom. That gives you conduit entry from four directions without pulling out a hole punch, useful when you are feeding through and continuing on in a wireway run.

It surface mounts through thru holes in the back of the box, so you fasten it straight to the wall or strut with your own anchors or screws sized to the substrate. No panel mounting bracket or backplate kit is part of the enclosure, and fasteners for the wall are not supplied.

It is built to UL 50, the standard covering enclosures for electrical equipment, and carries the NEMA Type 1 indoor rating. That combination is what an inspector looks for on an indoor pull or splice box in commercial construction. Country of origin is the US.

The cover is a screw-on type rather than a hinged door, but it has keyhole slots so once you back the plated screws out part way the cover lifts off and can be rehung without fully removing every screw. Handy if you service the box regularly. If you want a swing door you are looking at a hinged cover enclosure instead.

Body is 16 gauge galvanized steel, left unfinished (grey mill appearance) rather than painted. The zinc coating gives it reasonable resistance to surface rust in typical indoor mechanical and electrical rooms. If you need a painted finish to match existing gear, or corrosion protection in a wet or chemical area, specify a painted or stainless enclosure instead.

Order it as Eaton B-Line 12106 SCGV. The SCGV designation is the screw cover galvanized enclosure line, and the leading digits follow the box size: 12 high, 10 wide, 6 deep. Get the sequence right, because the same series uses similar numbers for different box sizes.

At 6 inches deep by 12 by 10, there is real working volume behind the cover for splice bundles, ground bars, or a small strip of terminal blocks, which is why this size gets used as a pull and splice point rather than a flush device box. Bear in mind the box ships as an empty enclosure: any DIN rail, terminal strips, or ground kit are separate items on your order.