B-Line Eaton series Type 1 junction boxes, 24" height, 10" length, 12" width, 1, Screw cover, SCGV NK enclosure, Surface mounted, Medium single door,

No. The 241210 SCGV NK carries a NEMA Type 1 rating, which is indoor only and gives no protection against water, dust ingress or corrosive conditions. Use it in dry indoor spaces such as electrical rooms, mechanical rooms and finished interior walls. For outdoor, damp, or hose-down locations you need a Type 3R, 4 or 4X enclosure instead.

It measures 24 inches high, 12 inches wide and 10 inches deep, which is why it is described as a medium single door screw cover box. The 10 inch depth is what matters most on a wall pull box, since it sets your bending space and how much gutter you have for conductors behind the cover.

The 241210 SCGV NK ships with no knockouts. Every conduit entry has to be punched or drilled in the field, which is usually what an electrician wants on a pull or junction box so hub locations match the actual raceway layout. Plan on a knockout punch set for the trades sizes you are running.

It is a surface mount enclosure with thru holes in the back for fastening straight to a wall, strut or backboard. The cover also has keyhole slots, so you can run the plated cover screws in part way, hang the cover, and then tighten, which is a real help when you are working a 24 inch box overhead on your own. Anchors or bolts suited to your wall substrate are supplied by the installer.

The enclosure is formed from 16 gauge steel, which is the usual commercial weight for a box this size and stiff enough that the cover stays flat and the body does not oil-can when you are pulling conductors through it. Galvanized steel also resists surface rust better than a bare cold-rolled painted box if the room gets humid, though the Type 1 rating still limits it to indoor dry locations.

It is built to UL 50, the standard for enclosures for electrical equipment, and country of origin is the United States. That combination is what most institutional and government specs are looking for on a submittal, alongside the NEMA Type 1 rating.

A screw cover box like the 241210 SCGV NK is the right call where you set the splices once and rarely go back in, such as a pull point or feeder junction. The cover comes fully off, which gives you open access on all four sides during the pull. If someone will be opening the box regularly for metering, controls or terminal work, a hinged cover enclosure is easier to live with, because a loose 24 by 12 inch screw cover is awkward to handle on a ladder.

Order as Eaton B-Line series 241210 SCGV NK. The number reads out as the dimensions and configuration: 24 by 12 by 10 inches, screw cover galvanized, no knockouts. That is the full catalogue designation, so there is no separate cover or trim number to add.

Empty weight is 21.7 lb. That is a two-hand lift but manageable solo, and the keyhole slots on the cover mean you are only handling the body while you fasten it to the wall through the back thru holes. Size your anchors for that weight plus whatever conduit and conductors will be loading the box.