B-Line Eaton series Type 1 junction boxes, 24" height, 8" length, 24" width, 1, Screw cover, SCGV NK enclosure, Surface mounted, Medium single door,

No. The 24248 SCGV NK is a NEMA Type 1 enclosure, which is indoor use only. It gives protection against incidental contact with the enclosed equipment and against falling dirt, but it is not rated against water, washdown, dust, oil, or corrosive conditions. If the box is going outside, under a sprinkler head, or anywhere it can be hosed down, you need a NEMA 3R, 4, or 4X enclosure instead.

It measures 24 inches high, 24 inches wide, and 8 inches deep. That 8 inch depth is the number to check first if you are stacking terminal blocks, wire duct, or a DIN rail assembly inside, and the 24 by 24 face is what you have to clear on the wall.

No knockouts. The 24248 SCGV NK is the NK (no knockout) version, so every conduit entry gets punched or hole-sawed in the field exactly where you want it. That is why electricians often specify it on a job with odd conduit runs, but it does mean you need a knockout punch set on site. If you would rather have factory openings, order the knockout version of the same screw cover box.

Surface mount, using thru holes already in the back of the enclosure. You supply the fasteners and anchors appropriate to the wall, no separate mounting kit is required. At 41.9 lb empty, back it into studs, unistrut, or masonry anchors rather than drywall alone, and remember conduit and wire add to that.

It carries UL 50, the standard covering enclosures for electrical equipment. That is usually what an inspector or a spec section on a commercial or institutional job is looking for on a Type 1 pull or junction box. It is also made in the US, which matters on public work with domestic sourcing requirements.

It is a screw cover, not a hinged door, so the cover lifts completely off once the plated screws are backed out. The cover has keyhole slots, which means you can loosen the screws rather than fully remove them and lift the cover free, then drop it back on the same screws when you are done. Plan on clear access in front of the box, since the cover has to come away rather than swing.

14 gauge galvanized steel body. That is a heavy wall for a Type 1 box, so it takes punching for large conduit and bumps in a mechanical room or plant corridor without oil-canning. The galvanized surface is unfinished, grey mill finish, not painted, so it resists rust in a dry indoor environment as-is and can be painted if the spec calls for a color.

The catalog number is 24248 SCGV NK from Eaton's B-Line series. The number reads as the size and type: 24 high, 24 wide, 8 deep, screw cover galvanized, no knockout. Distributors cross-referencing it should note the SCGV designation is what separates it from the hinged and continuous-hinge versions of the same footprint.