B-Line Eaton series Type 1 junction boxes, 36" height, 8" length, 24" width, 1, Screw cover, SCGV NK enclosure, Surface mounted, Medium single door,

No. The 36248 SCGV NK is a NEMA Type 1 enclosure, which is indoor use only, for protection against incidental contact and falling dirt. It has no gasket and no rating against water, dust, oil, or corrosive conditions. For a wet location, exterior wall, or hosedown area you need a Type 3R, 4, or 4X enclosure instead.

The enclosure measures 36 inches high, 24 inches wide, and 8 inches deep. The leading digits of the catalog number match that: 36 x 24 x 8. Lay out your wall space and conduit entries against those numbers before you order, because at 8 inches deep it needs real clearance in front for the cover screws and wire bending room.

No knockouts. The NK in 36248 SCGV NK means no knockout, so the body ships blank and you punch or hole-saw every conduit entry where you want it. That is the point of the NK version, it lets you set entries to suit the run instead of working around factory locations, but budget the tooling time and plan on sealing washers or connectors sized to the holes you cut.

Surface mount, using thru holes in the back of the enclosure, so it bolts flat to a wall or to Unistrut. It is not a flush or recessed box. Anchors, bolts, or strut nuts are selected for your wall type and are not part of the enclosure, and at 58.6 lb you want fasteners into structure or backing, not drywall alone.

It carries UL 50, the standard for enclosures for electrical equipment, and it is a NEMA Type 1 indoor enclosure made in the US. That combination is what most commercial and institutional specs call for on an indoor pull or junction box. Give the submittal the catalog number 36248 SCGV NK so the reviewer sees the no knockout, screw cover, galvanized configuration.

It is a screw cover, not a hinged door, so the whole cover lifts away for access. The cover has keyhole slots and plated screws, meaning you can back the screws out part way and lift the cover off the slots rather than chasing loose hardware on a ladder. The full enclosure is 58.6 lb, so on a 36 by 24 box plan on two hands or a second set for the hang.

It ships unfinished, in grey galvanized steel, with no paint. The galvanizing is the corrosion protection, which handles the humidity of a typical mechanical or utility room, but as a Type 1 indoor box it is not meant for direct water exposure. If you need a painted finish to match other gear, this is not the one, and any cut conduit openings should get cold galvanizing touch up.

Screw cover suits a pull or junction box you open rarely, at splices, taps, and conduit transitions. The cover comes fully off, which gives unobstructed access to all four sides of the box during pulls, and there is no door to swing into a tight corridor. If you are housing terminal strips, controls, or anything an operator opens routinely, a hinged door version is the easier daily choice. The 36248 SCGV NK is the screw cover configuration.

The body is 14 gauge galvanized steel, the heavier of the common enclosure gauges and why a 36 by 24 by 8 box lands at 58.6 lb. It holds its shape when you punch conduit entries and when the cover screws are torqued down, which matters on a box this size carrying multiple heavy feeders.