B-Line Eaton series wall mounted panel enclosure, 24" height, 6" length, 20" width, 4X, Hinged cover, 4XSS63PT enclosure, Wall mount, Medium single d

Yes. The 24206-4XSS63PT carries a NEMA 4X rating and is built from 316 stainless steel with a seamless poured in-place gasket, which is the combination you want for hosedown areas, food and beverage plants, water treatment, and salt-air coastal sites. 316 is the marine-grade alloy, so chloride exposure is what it is specified for.

It is a wall mount enclosure with external mounting feet, so the box stands off the wall rather than sitting flush. That standoff is deliberate on a 4X stainless box: it lets the wall surface be washed down behind the enclosure and keeps water from pooling at the back. Fasteners go through the feet only, so the enclosure walls are never drilled and the 4X seal stays intact.

No, and you should not drill any. The 4X rating on the 24206-4XSS63PT depends on an unbroken envelope plus the seamless poured in-place gasket. Any hole you add, including a drain, has to be closed with a rated 4X fitting or hub or the rating is void. Use gasketed conduit hubs for every penetration and enter from the bottom where you can.

The description covers the enclosure body, hinged cover, external mounting feet and gasket. A sub-panel is ordered separately on B-Line 4XSS enclosures, so plan on specifying a back panel sized for a 24 x 20 inch box along with any DIN rail, terminal kit, or thermal management you need.

Yes. The cover has a key lock padlock provision, so you can either key it or hang a padlock or lockout hasp on it. Combined with the 3-point latching handle, the door pulls tight along its full height, which is what keeps a 24 inch door sealed against the gasket.

It is built to UL 508A, the standard for industrial control panels, so it is the right housing when you are assembling motor starters, drives, or PLC controls for an inspected installation. Note the certification covers the enclosure, not your panel build, which has to be assembled and labeled to 508A by the panel shop.

Walls are 14 gauge 316 stainless. That is the standard heavy-duty thickness for industrial single door enclosures and it supports a loaded back panel without oil-canning. The finished box weighs 42.3 lb empty, so factor that plus your panel weight into wall anchor selection, especially on stud or block walls.

For anything you open regularly, hinged is the practical choice. The 4XSS63PT uses a hinged door with a 3-point latching handle, so a technician can open it one-handed and there are no loose cover screws to drop or lose during service. A screw cover box makes more sense for a sealed junction you never revisit, since it has no handle hardware to maintain.

The exterior is a #4 brushed finish on 316 stainless, the standard directional satin grain used in food processing and clean environments because it wipes down easily and hides handling marks. It is not a painted enclosure, so there is no coating to chip in a washdown area.

Country of origin is the US. That matters on federal, state, and municipal work with domestic sourcing language in the spec, and it is worth capturing on the submittal along with the UL 508A certification.