Emtek 13A5 Multi Point Lock Trim (Door Config #3) - Brass Plates, Modern Style (1.5" x 11"), Dummy Pair

Trim only. The 13A5 set is plates and handles for a swinging patio door; the multi point mortise lock box is a separate order. If you are replacing worn or dated handles on an existing multi point door, that is exactly what this covers. If you are building a new door, you need the lock body too.

Dummy pair means there is no latch or key action at all. Both sides get a fixed handle on a plate, pulled to open and push to close, with no cylinder and no keying. It is what goes on the inactive leaf of a French pair, or on a door where the locking is handled elsewhere. If you need the handle to actually drive the multi point lock, a dummy is the wrong function.

Yes, 1-3/8 inch through 1-3/4 inch doors are covered, which spans both the common older interior thickness and the standard 1-3/4 inch slab. There is a door thickness field on the order so you can state the actual measured thickness of your door.

No door prep. The 13A5 is surface mount, so the plates sit on the face of the door rather than dropping into a bored or mortised pocket. On a dummy pair that keeps the retrofit simple, though the handle spindle and plate holes still have to line up with what is already drilled on the door.

4-1/8 inches center to center, on a plate measuring 1-1/2 by 11 inches. That is Emtek's Door Configuration #3 layout, referenced to Andersen doors, with the cylinder position above the handle. Measure the existing hole spacing on your door before ordering: if your door does not measure 4-1/8 inches between centers, you are on a different Emtek configuration and need the trim built for it.

Yes, handing is a required choice, right hand or left hand. Even though a dummy has no latch, the lever and plate are built to the swing of the door so the handle points the right way. Stand outside the door: if the hinges are on your right, it is right hand.

Lever choice is required and the range is wide, 51 styles in all. That runs from the modern L-Square, T-Bar and R-Bar bars in Faceted, Hammered, Knurled, Tribeca, Straight Knurled and White Marble treatments, through Athena, Helios, Hermes, Luzern, Poseidon and Stuttgart, to traditional shapes like Cortina, Milano, Merrimack, Turino, Coventry, Ribbon and Reed, Rope, Rustic, Santa Fe, Wembley, Arts and Crafts and Hammered. Any brass lever works with these brass plates.

Seven: Oil Rubbed Bronze (US10B), Polished Nickel Lifetime (US14), Satin Nickel (US15), Flat Black (US19), Polished Chrome (US26), Unlacquered Brass (US3NL) and Satin Brass (US4). Unlacquered brass is the one that will patina over time rather than hold its as-shipped look, which matters if you are trying to match other openings in the house that are already aged.

Residential grade. The 13A5 is swinging patio door hardware for houses and residential units, not a commercial opening. Property managers standardizing across multi-family patio doors can use it, but for a commercial entry with traffic and code requirements you want commercial-rated hardware instead.

Purely mechanical. No electronics, no motor, no wiring to run to the door. It is a brass plate and lever assembly, so there is nothing to power and nothing to fail when the power drops.