NUVO Lighting 65-862-4 LED Area Light Type IV, 150W, Bronze Finish, 4000K, 277-480V

No. The 65-862-4 is the high-voltage version, built for 277V to 480V only. On a 120/208/240V panel it is the wrong fixture. Confirm your pole circuit is 277V or higher (typically a 480V three-phase site or a 277V leg off a commercial panel) before ordering this one; for 120-277V service you need the standard-voltage version of the area light instead.

A slip-fitter mount ships with the fixture, so it goes straight onto a round or square pole tenon or a davit arm sized for a slip-fit. If your pole has a drilled arm pattern rather than a tenon, you will need an adapter plate, which is not part of this package. The fixture itself weighs 8.08 lbs, so pole and arm loading is rarely the limiting factor.

Output-wise it lines up. At 19,507 lumens from 150W, the fixture sits in the range typically used to swap out a 320W to 400W metal halide area light, which puts out similar usable light after lamp depreciation. Two things to check: the mount, since the slip-fitter needs a pole tenon, and the circuit voltage, since this version only accepts 277V to 480V. Rated life is 50,000 hours on an integrated LED array, so there is no lamp or ballast to re-stock.

Yes, it carries a Wet location rating and is an outdoor fixture, so direct rain exposure on a pole top or building face is fine. The housing is die-cast aluminum, and the fixture is cULus certified for both US and Canadian installations.

Type IV throws light forward in a wide semicircular pattern away from the pole, which is what you want along a property perimeter, at the edge of a lot, or on a building wall facing the drive aisle, where you do not want spill behind the fixture. If the pole sits in the middle of a lot with parking on both sides, a Type III or Type V distribution covers that better. The 65-862-4 is the Type IV, 150W version producing 19,507 lumens.

The fixture is dimmable, so it can be tied into a 0-10V style control scheme for after-hours step-dimming. The 4000K color temperature is fixed, not field-selectable, so if your site standard requires 3000K or 5000K you need to order that CCT as a separate part rather than switch it at the pole.

It will match anything already running at 4000K neutral white, which is the most common spec for parking and perimeter lighting. Against 5000K fixtures it will read noticeably warmer, and against 3000K it will read cooler. CRI is 80, typical for site lighting. Since the color temperature on the 65-862-4 is fixed rather than selectable, matching has to happen at the order, not at install.

No. The LED array is integrated into the fixture, so there is no socket, lamp, or ballast to stock or change. Rated life is 50,000 hours, and at end of life the fixture is replaced rather than relamped. For MRO planning, that means no lamp SKU to carry, but it also means a failure is a fixture swap.

Order NUVO Lighting 65-862-4 (also written 65/862/4). That number covers the 150W Type IV area light in bronze, 4000K, 277-480V. The finish on this model is bronze only.

The housing measures 20.71 inches long, 12.4 inches wide, and 3.11 inches high. That is a low-profile shoebox form, much slimmer vertically than the HID boxes it usually replaces, so on an older pole you may see the shadow of a larger previous fixture on the arm. At 8.08 lbs it adds very little EPA or dead load to the pole.

Yes. Lead is listed as a Prop 65 chemical for the 65-862-4, so California jobs need the warning carried through on submittals and labeling. The fixture is also RoHS compliant.