NUVO Lighting 65-864-4 LED Area Light Type IV, 200W, Bronze Finish, 4000K, 277-480V

No. The 65-864-4 is the high-voltage version, rated 277V to 480V. On a 208V or 240V panel it will not operate, and you need the 120-277V multi-volt version of the fixture instead. It is the right choice for 277V lighting circuits off a 480/277V wye service, which is what most commercial parking lots and site poles are fed from.

It ships with a 2-3/8 inch slip-fitter mount, so it slides onto a 2-3/8 inch OD tenon or horizontal mast arm and clamps down. That covers standard pole tenons and bullhorn arms. If your pole is a square shaft with no tenon and no arm, you need a separate arm or adapter, because a slip-fitter has nothing to bolt flat against.

Yes. It is an outdoor fixture with a Wet location rating and a cULus certification, so it can go on an exposed pole or wall with direct rain on it. The housing is die-cast aluminum, which is what you want on a site pole for heat dissipation and corrosion resistance.

It is a fixed 4000K neutral white with 80 CRI, and the color temperature is not selectable, so there is no field switch to match a warmer or cooler head. If your existing lot fixtures are 5000K, this one will read noticeably warmer alongside them. For a uniform lot, keep every pole at 4000K or change them all out together.

Type IV throws light forward in a wide, roughly semicircular pattern, so it is used at the perimeter of a lot, on building walls, and along the edges of driveways where you want the light pushed away from the fixture and no spill behind it. Type III is for mounting along the side of a lot and gives a wider lateral spread with more backlight; Type V is symmetric and goes in the middle of a lot or on a center pole. The 65-864-4 is the Type IV, 200W version.

At 26,051 lumens delivered, the 200W 65-864-4 lands where a 400W to 450W metal halide or HPS shoebox used to sit, since those dropped well below their initial lumens after a year or two of service. For like-for-like pole spacing on a relamp, check your existing pole layout and target footcandles rather than matching nameplate wattage.

The fixture is dimmable, so it will work with an external 0-10V type control or a central lighting management system for after-hours setback. No photocell is included in the box, only the 2-3/8 inch slip-fitter mount, so a photocell or contactor control has to be specified separately or handled at the panel.

No. The LED array is integrated, with no lamp base and no separate bulb, so there is nothing to relamp. Rated life is 50,000 hours, and at end of life the fixture head is replaced as a unit. Plan your MRO stock around spare heads, not lamps.

The head weighs 8.42 lbs and measures 30.28 inches long, 12.39 inches wide, and 3.11 inches high. That is a light, low-profile shoebox, so on a multi-head pole the EPA and weight load stay modest compared with an old HID housing. Confirm the total EPA against your pole rating when you hang two or more heads.

Bronze only. That is the single finish offered on the 65-864-4, which is the usual match for bronze poles and arms on commercial sites. There is no black or white option on this model number.

Yes, lead is listed as a Prop 65 chemical for this fixture. The fixture is also RoHS compliant. Institutional and government buyers who need the warning language on submittals should note the lead listing.