NUVO Lighting 65-864-5 LED Area Light Type V, 200W, Bronze Finish, 4000K, 277-480V

Yes. The 65-864-5 is a high-voltage fixture with a 277V-480V input range, so it works on 277V, 347V-range and 480V circuits within that window. It will not run on a 120-277V multi-tap panel circuit at 120V, so if your parking lot poles are fed 120V or 208V you need the low-voltage version of the fixture instead.

Type V throws light in a symmetrical circular pattern all the way around the fixture, so it suits pole locations in the middle of an open area: interior parking lot rows, yards, storage lots, and campus quads. If the pole sits along a property line or at the edge of a lot where you need the light cut off on one side, a Type III or Type IV forward-throw optic is the better choice. The 65-864-5 puts out 26,051 lumens at 200W.

At 26,051 lumens the 65-864-5 lands in the range typically used to replace 400W to 750W metal halide area heads, and it draws 200W doing it. Before swapping one for one, check two things on your poles: the tenon has to accept the included 2-3/8 inch slip-fitter, and the circuit has to be in the 277V-480V band. Many older MH lots are fed 480V, which this fixture handles directly.

Yes, it carries a Wet location rating and is built for outdoor use, with a die-cast aluminum housing. It is cULus Certified.

The fixture weighs 8.42 lbs and measures 30.28 inches long, 12.39 inches wide, and 3.11 inches high. That low 3.11 inch profile and light weight keep the load on an existing pole modest, which matters when you are reusing poles that previously carried heavy HID shoeboxes.

No. The 65-864-5 is fixed at 4000K and is not CCT selectable, so there is no field switch for 3000K or 5000K. If you are standardizing a site at a different color temperature, order the fixture built at that CCT rather than this one. The 4000K output is 80 CRI.

The fixture is dimmable, so it can be driven by a 0-10V control channel for scheduled or occupancy-based dimming on a lot. No photocell, sensor, or control module is included with it; the only component in the box is the 2-3/8 inch slip-fitter mount, so order any photocontrol or sensor separately.

No. The light source is an integrated LED with no lamp base, so there is no bulb to change. The LED board and driver are part of the fixture, rated at 50,000 average hours. Maintenance planning on these is fixture replacement, not relamping, which is the usual tradeoff when converting a site off HID heads.

It is RoHS compliant. It also carries a California Proposition 65 warning for lead, which is standard disclosure on many die-cast metal lighting housings and is relevant if you are shipping to or installing in California.

Bronze is the only finish offered on the 65-864-5. Bronze is the common site-lighting finish, so it will match most existing poles and arms on a commercial lot without repainting.