NUVO Lighting 65-867 LED Area Light Type III, 240W, Bronze Finish, 5000K, 277-480V

The 65-867 is a high-voltage fixture, rated 277V to 480V. That covers 277V single phase and 480V service common in commercial and industrial sites. It will not run on 120V or 208-240V, so if your pole circuit is low voltage you need the 120-277V version of the fixture instead.

A 2-3/8 inch slip-fitter mount is included, so it slides onto a 2-3/8 inch OD tenon or davit arm and clamps down. If your pole has a drilled-hole or square-arm pattern rather than a round tenon, you need a separate arm or adapter plate, which is not included.

Type III throws light forward and to the sides in an asymmetric pattern, which suits fixtures mounted along the edge of a parking lot, a driveway, or a roadway shoulder where you want the light pushed out over the pavement and kept off the property line behind the pole. For a pole in the middle of a lot needing light on both sides, a Type V or Type II layout is the better choice.

At 240W drawing and 32,585 lumens delivered, the 65-867 is in the range used to replace 750W to 1000W metal halide or HPS area lights, which is the usual one-for-one swap at that output. The LED output is delivered lumens out of the fixture, not lamp lumens, so the usable light on the pavement is higher than the raw number comparison suggests.

Wet location rated and built for outdoor use, with a die-cast aluminum housing that doubles as the heat sink. cULus certified and RoHS compliant. Note it carries a California Prop 65 notice for lead.

The fixture is dimmable, so it can be driven from an external 0-10V type control or scheduled down for after-hours setback. The control device, photocell, or dimming leads interface are not part of the fixture package and need to be specified separately.

The 65-867 is fixed at 5000K with 80 CRI. It is not a field-selectable CCT fixture, so if your existing lot runs 4000K the color will read noticeably cooler and bluer side by side. For a mixed-age lot, standardize on one CCT or expect a visible difference.

No. The LEDs are integrated into the fixture, there is no socket or replaceable lamp, and rated life is 50,000 hours. When the array or driver goes, you service the driver or replace the head. Plan your fleet maintenance on head replacement rather than relamping.

The housing measures 30.28 inches long, 12.39 inches wide and 3.11 inches high, weighing 11.93 lbs. That low profile and light weight keep the wind load modest, which matters when you are hanging two or three heads on one existing pole and checking the pole's EPA rating.

Bronze only, which is the standard finish for commercial pole and parking lot heads and blends with most existing bronze poles and arms. There is no black or white option on this model number.