NUVO Lighting TH414 1-Light, LED, 12W Track Head, Pinch Back, Black, 36 degree Beam

No. The TH414 track head is rated for dry locations only and is an indoor fixture. Keep it out of covered exterior soffits, bathrooms with shower steam, and refrigerated or wash-down areas. For those openings you need a damp- or wet-rated fixture instead.

The TH414 is a 120V line-voltage track head with an integrated LED and no separate driver or low-voltage transformer. It mounts to ceiling track. Because it is a pinch-back head, the back of the fitting pinches into the track channel, so confirm your track is the same system profile before ordering, 120V line-voltage track systems from different makers are not interchangeable.

Dimming is supported on the TH414. It is a 120V integrated LED head, so it needs an LED-compatible forward- or reverse-phase dimmer rather than an old incandescent-only control. At 12W per head, several heads can share one circuit without approaching the minimum load on most LED dimmers, but check the dimmer's stated minimum and maximum LED load for the head count you plan to run.

The TH414 is a fixed color temperature head, it is not CCT selectable, so there is no field switch to change the white point. If you are mixing it into an existing run of track heads, order all heads to the same color temperature so the ceiling reads consistently. One finish is offered on this head, black.

Extension is 5.5 inches from the mounting surface, with a body measuring 3.63 inches long by 2.88 inches high by 2.88 inches wide. That 5.5 inch drop matters in low-clearance spaces, corridors, and anywhere a head could be struck, and it is also what determines how far you can aim it before the head hits the track. Fixture weight is 1.05 lbs.

There is nothing to relamp. The LED is integrated into the TH414 head, so the light source is not replaceable and the whole head is swapped at end of life. Average rated life is 30,000 hours, which works out to roughly seven years at 12 hours a day. For MRO planning, that means no bulb stock to carry for these heads, just spare heads.

The TH414 carries a cETLus safety listing, covering both US and Canadian requirements, and it is RoHS compliant. It is listed for dry indoor locations. Note that it carries a California Prop 65 notice for lead.

36 degrees is a flood beam. It is the right pick for washing shelving, merchandise runs, countertops, and general accent where you want overlapping pools of light from heads spaced along a track. For a single framed piece or a narrow display pedestal where you want a tight edge on the light, a narrower spot beam head in the same 12W class is the better tool, the 36 degree spread will spill well past the frame.

Yes, NUVO publishes both an installation instruction sheet and a full photometric spec sheet for the TH414, and both are linked in the product details. The spec sheet is the document to hand over if the job needs submittal paperwork for the 12W, 1020 lumen, 120V head.