SATCO Lighting S11419 14W A19 LED, 5000K, 100W Replacement, Medium Base, 220 degree Beam Angle, 10-Pack

No. The S11419 is a non-dimmable lamp. Put it on a dimmer circuit and you can expect flicker, buzz, or premature failure. If the fixture is controlled by a dimmer, either swap the switch for a standard toggle or spec a dimmable A19 instead. It is also not a three-way lamp, so it will not step through levels in a 3-way socket.

Yes, it is an enclosed rated lamp, so closed glass globes, jelly jars, and flush-mount dome fixtures are fair game. Burning position is universal, so base up, base down, or horizontal all work. That combination is what makes it practical for corridor domes and closet fixtures in multifamily buildings.

It is rated as a 100W incandescent equivalent and puts out 1520 lumens on 14 watts, which is in line with what a 100W A19 incandescent delivered. The light itself looks different though: 5000K is a cool daylight white, not the warm yellow of the incandescent it is replacing. If you are relamping only part of a room, the mismatch will be obvious.

It is classified as an indoor lamp with a damp location rating. Damp covers bathrooms, laundry rooms, and covered areas out of direct weather, but not wet locations where rain or spray hits the fixture. For an open exterior fixture or anything exposed, use a wet-location rated lamp.

No. This lamp is flagged non-compliant for California, so it should not be specified for jobs in that state. Look for a California-compliant A19 LED for those projects.

5000K reads as daylight white, cool and slightly blue. It suits garages, laundry rooms, basements, back-of-house corridors, and work areas where you want crisp visibility. For living rooms and bedrooms most tenants prefer 2700K or 3000K. CRI is 80, standard for general-purpose lighting but not a color-critical space. This lamp is fixed at 5000K, with no selectable CCT switch.

Beam spread is 220 degrees, so light throws well past straight down and out to the sides. That is omnidirectional-style coverage suited to table lamps, open ceiling fixtures, and enclosed globes where you want the whole room lit. It is not a directional lamp, so for aimed accent or task light you want a BR or PAR reflector instead.

Average rated life is 10,000 hours. Run continuously that is a bit over 13 months; on a typical 12-hour corridor schedule it is roughly two years before you are back on a ladder. That matters when you are budgeting relamp labor across a building, and it is why these ship 10 to a pack.

The lens is white-finish polycarbonate over a thermoplastic PBT base, with a white housing. No glass, so it takes handling on a ladder or in a stock cart better than a glass lamp, and the white diffusing lens keeps the LED sources from showing as hot spots in an open or bare-socket fixture.

It is not DLC listed, so it will not qualify under programs that require a DesignLights Consortium listing. It is FCC compliant. If a rebate is part of your project budget, check the program's qualified products list before committing to this lamp.