SATCO Lighting S11867 13W LED, Fire Rated 6in Direct Wire Downlight, Round Shape, CCT Selectable, 120V, Dimmable, Remote Driver

The S11867 is a remote driver downlight, so the LED driver is a separate component wired outside the housing rather than sitting behind the trim. That is what lets the fixture body sit only 0.69 inches high at 6.81 inches diameter, which is why it goes into shallow plenums and tight joist bays where an integral-driver can. Plan the rough-in with a location for the driver that stays accessible. It is direct wire at 120V, 60Hz, so it lands on a standard branch circuit with no J-box adapter or lampholder.

That is the point of the CCT selectable switch on the S11867. One part number covers 2700K, 3000K, 3500K, 4000K and 5000K, set on the fixture at install. A property manager can stock a single SKU and still put 2700K in units, 3500K in corridors and 4000K in back-of-house. Output is 1050 lumens at 13 watts regardless of which temperature you select.

Wet location rated, and cULus certified. That covers a shower or tub enclosure. The fixture is classified for indoor use, so a covered porch or exterior soffit is outside what the rating states, even though the wet rating would otherwise suggest it. For an outdoor soffit, specify a downlight listed for outdoor locations.

The S11867 is a fire rated downlight, so the fixture itself is built to be installed in a fire rated ceiling assembly without a separate cover box over the fixture. The remote driver is a separate component and is not part of that fire rating, so it has to be located outside the rated assembly or handled per the assembly's own requirements. Wiring, penetration and assembly details are in the Satco installation instructions supplied with the fixture.

The S11867 is dimmable on 120V line voltage, which is the standard forward or reverse phase wall dimmer circuit. The dimming behavior belongs to the remote driver, not the trim, so check the driver against your dimmer model, and match the fixture count on a circuit to the dimmer's LED load rating. Compatible dimmer listings are published in the Satco spec sheet for this fixture.

California T24 Listed, so it can be specified on Title 24 work in California. It is also FCC compliant and RoHS compliant, which covers the two other boxes institutional and government submittals usually ask for on LED fixtures. Rated life is 50,000 hours.

Wattage is fixed at 13W on the S11867. Only the color temperature is selectable, across 2700K, 3000K, 3500K, 4000K and 5000K. If your project needs a field-adjustable lumen or wattage setting to tune each space, specify a downlight that lists wattage selectable, not this one.

No. The LED is integrated, so there is no lamp base and no socket to relamp. When the fixture reaches end of life you replace the whole downlight. Rated average life is 50,000 hours, and the housing is aluminum and steel rather than plastic.