You may also like
SATCO Lighting S12116 4.5W, B11 LED, Clear, 350 Lumens, 4000K, European Base, 120V
4.5 Watt - B11 LED - Clear - 350 Lumens - 4000K - European base - 120 Volt
Manufacturer Resources
Spec Sheet
Product Specs
- Amps:
- 0.038A
- Avg Rated Hours:
- 15000
- Burning Position:
- Universal
- CCT Selectable:
- No
- DLC Approved:
- No
- Dimmable:
- Yes
- FCC Compliant:
- Yes
- Lamp Filament:
- LED Filament
- Lamp Shape:
- B11
- Lens Finish:
- Clear
- Lumens:
- 350L
- Operating Frequency:
- 60Hz
- Product Type:
- Candle
- Three-Way:
- No
- Warranty:
- 3 Year Limited
- Product Group:
- Indoor Lighting
- Product Subgroup:
- Light Bulbs
- Bulb Base:
- European Intermediate
- Base Material:
- Glass
- Incandescent Equivalent:
- 40W
- Location Rating:
- Damp
- CRI:
- 80
- Subcategory:
- LED
- Title 24 Compliant:
- Yes
- Bulb Type:
- LED
- Product Voltage:
- 120V
- Beam Spread Angle:
- 300
- Light Temperature:
- 4000K
- Product Category:
- Light Bulbs
- Product Wattage:
- 4.5W
- Product Weight:
- 0.04 lb
- Product Material:
- Glass
Satco Lighting S12116 – Frequently Asked Questions
1) Is the Satco S12116 4.5W LED candle bulb dimmable?
Yes, the S12116 is dimmable on a 120V, 60Hz circuit. It draws 0.038A, so a run of these on one dimmer adds up to very little load, which is the usual reason LED candle lamps flicker or fail to dim smoothly on older magnetic dimmers. A dimmer rated for low-wattage LED loads is the right choice for a chandelier full of them.
2) What incandescent candle bulb does this 4.5 watt Satco LED replace?
It replaces a 40 watt incandescent candle lamp, putting out 350 lumens on 4.5 watts. Same B11 torpedo shape, so it drops into the same chandelier arms and sconces without the shade or socket cover fouling.
3) Can I use this Satco B11 LED filament bulb in an open bathroom or covered porch fixture?
It carries a damp location rating, so an enclosed bath fixture, a covered porch, or a breezeway is fine. Wet location, meaning direct rain or spray, is not. It also burns in any orientation, base up or base down, so it works in an upward candelabra chandelier or a downward sconce.
4) Is 4000K too cool for a chandelier or dining room fixture?
4000K is a neutral white, noticeably crisper than the warm 2700K look most people expect from a decorative chandelier. It reads well in offices, corridors, lobbies, and commercial common areas where you want a clean white. For a hospitality dining room or a residential unit being matched to existing warm lamps, a 2700K B11 is the better match. Note the S12116 is a fixed 4000K, not CCT selectable.
5) Does the clear glass on this Satco LED candle bulb show the filament?
Yes. It is an LED filament lamp behind a clear glass lens, so you see the lit filament strands the way you would in a vintage style incandescent. That is the look you want in an exposed chandelier or a glass front fixture. If the fixture leaves the lamp bare at eye level and you want less glare, a frosted B11 is the softer choice.
6) How wide does the light spread from a B11 LED filament lamp like the S12116?
The beam spread is 300 degrees, which is near omnidirectional. That matters in a chandelier or an open sconce where the lamp has to throw light sideways and up, not just forward the way a directional LED candle with a heat sink base does.
7) How long will these last in a hotel corridor or lobby chandelier that runs all day?
Average rated life is 15,000 hours. On a fixture burning roughly 12 hours a day that is about three and a half years before relamping, which is why properties standardize on them for high-arm chandeliers that need a lift to service. CRI is 80, adequate for corridors and common areas.
8) Does the Satco S12116 meet California Title 24?
Yes, the S12116 is Title 24 compliant, and it is FCC compliant as well. It is not DLC listed, so if your utility rebate program requires a DLC qualified product, this lamp will not qualify for that program.
9) Will this work as a 3-way bulb in a socket with high, medium and low settings?
No. The S12116 is not a three-way lamp. In a 3-way socket it will light on one level only. For dimming, use it on a dimmer circuit instead, which it does support.
How fast can I get the Satco Lighting S12116 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Satco Lighting S12116 come with a warranty?
Absolutely. The Satco Lighting S12116 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Satco Lighting S12116?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Satco Lighting S12116 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.