SATCO Lighting S12413 5W LED A19, Soft White, 3000K, Medium Base, 90 CRI, 120V

Yes on both counts. The S12413 is an enclosed rated lamp, so it can run inside a sealed globe, jelly jar, or flush-mount drum without the heat shortening its life. It also carries a Wet location rating and is listed for indoor and outdoor use, which covers porch fixtures, covered walkways, and exterior sconces exposed to rain. It can be burned in any position, base up, base down, or horizontal.

Dimmable, yes, on a 120V line at 60Hz. It is not a three-way lamp, so do not put it in a three-way socket expecting low/medium/high steps. Draw is 0.042A per lamp, which is low enough that a typical residential dimmer will be well under its minimum load if you only have one or two on the circuit, so watch for flicker on lightly loaded dimmers in stairwells and closets.

A 90 CRI rating means colors render close to natural light, which matters in hospitality guest rooms, retail display, healthcare exam spaces, and anywhere paint, fabric, or skin tone has to look right. Most commodity LED A19s sit at 80 CRI. Paired with the 3000K soft white color, the S12413 is aimed at spaces people actually look at rather than back-of-house.

Beam spread is 320 degrees, near-omnidirectional. That is the filament-lamp advantage over a chip-on-board A19, which throws mostly forward and leaves a dark patch behind the base. In a chandelier, ceiling globe, or table lamp with a shade, the S12413 lights the shade and the ceiling rather than dumping everything downward.

Average rated life is 15,000 hours. For a property manager running corridor or exterior fixtures roughly 12 hours a day, that works out to about three and a half years before a planned group relamp. At 5 watts and 0.042A, a long run of these on one 120V branch circuit draws very little, so you are rarely circuit-limited when standardizing a building on them.

It is an LED filament lamp with a glass envelope in a soft white finish, so the filaments are diffused rather than exposed clear glass. Construction is aluminum and glass. In an open fixture where the lamp is visible, such as a pendant or an exposed-socket sconce, the soft white finish keeps the glare down compared with a clear filament bulb.

No. It is fixed at 3000K soft white with no CCT selector switch on the base. If a job calls for one SKU that can be field-set to 2700K, 3000K, 4000K and so on, this is not that lamp, you would need to spec a CCT selectable A19 instead.

No, it is not DLC approved, so it will not qualify under a DesignLights Consortium based utility incentive. It is FCC compliant and marked lawful for sale in California, which covers the usual procurement questions on a spec sheet review.