You may also like
SATCO Lighting S21225 5.5W G16.5 LED, White, Medium Base, 90 CRI, 4000K, 120V
5.5 Watt G16.5 LED - White - Medium base - 90 CRI - 4000K - 120 Volt
Manufacturer Resources
Spec Sheet
Product Specs
- Amps:
- 0.046A
- Avg Rated Hours:
- 15000
- Burning Position:
- Universal
- CCT Selectable:
- No
- DLC Approved:
- No
- Dimmable:
- Yes
- Enclosure Rating:
- Enclosed Rated Lamp
- FCC Compliant:
- Yes
- Lamp Filament:
- LED Filament
- Lamp Shape:
- G16.5
- Lumens:
- 500L
- Operating Frequency:
- 60Hz
- Product Type:
- Globe
- Three-Way:
- No
- Warranty:
- 3 Year Limited
- Product Group:
- Indoor Lighting
- Product Subgroup:
- Light Bulbs
- Bulb Base:
- Medium
- Base Material:
- Glass / Nickel Plated Aluminum
- Incandescent Equivalent:
- 60W
- Location Rating:
- Wet
- CRI:
- 90
- Subcategory:
- LED
- Location Indoor/ Outdoor:
- Indoor/Outdoor
- Title 24 Compliant:
- Yes
- Bulb Type:
- LED
- Product Voltage:
- 120V
- Beam Spread Angle:
- 320
- Light Temperature:
- 4000K
- Product Category:
- Light Bulbs
- Product Wattage:
- 5.5W
- Product Material:
- Glass / Nickel Plated Aluminum
- Product Weight:
- 0.05 lb
Satco Lighting S21225 – Frequently Asked Questions
1) Can the Satco S21225 G16.5 LED globe bulb go in an enclosed fixture?
Yes. The S21225 is an enclosed rated lamp, so it can be installed in a closed globe, a flush mount, or a sealed vanity fixture without voiding the rating. It is also wet location rated and listed for indoor or outdoor use, which covers covered porch fixtures and bath fixtures where humidity is high.
2) Will the Satco S21225 replace a 60 watt incandescent globe bulb?
It is built as a 60W incandescent equivalent, drawing 5.5 watts and putting out 500 lumens at 4000K. The base is a standard medium screw base on 120V, so it drops into the same socket as the 60W globe you are pulling out. The difference you will see is color: 4000K is a cool, neutral white, noticeably whiter than the warm yellow of the incandescent it replaces.
3) Does the Satco S21225 meet California Title 24 for a multifamily or hospitality retrofit?
Yes, the S21225 is listed as Title 24 compliant, and its 90 CRI supports the high color rendering those requirements lean on. It is also FCC compliant. It is not DLC listed, so it will not qualify for rebate programs that require DLC.
4) Will a 4000K 90 CRI globe bulb match the warm bulbs already in my building?
No. At 4000K this lamp reads as neutral/cool white and will look obviously bluer next to the 2700K warm white globes common in residential and hospitality fixtures. If you are relamping a corridor or a bank of vanities, do the whole run in one color temperature. Where the 4000K does pay off is color accuracy: 90 CRI renders skin tones and finishes far more faithfully than a typical 80 CRI lamp.
5) Is the Satco S21225 G16.5 LED dimmable?
Yes, the S21225 is a dimmable lamp on 120V, 60Hz. It is a single color temperature lamp at 4000K, not CCT selectable and not three-way, so dimming is the only output adjustment available. On a retrofit, keep in mind that a 5.5W load is small and older incandescent dimmers may not drive it smoothly in low quantities.
6) Can this G16.5 LED globe be installed base-up in a ceiling fixture?
Burning position is universal, so the lamp can be run base-up, base-down, or horizontal. That matters for enclosed ceiling flush mounts and pendant globes where heat collects around the base; the S21225 is rated for enclosed fixtures in any orientation.
7) Is the S21225 a clear filament bulb or a frosted one?
It is a white (frosted) G16.5 globe built on LED filament construction, so you get the filament look diffused rather than the exposed clear-glass filament appearance. The 320 degree beam spread gives near-omnidirectional output, which is what you want in an exposed globe fixture or a bath bar where the bulb is visible from every angle.
8) How many of these 5.5W bulbs can I put on one 15 amp lighting circuit?
Each S21225 draws 0.046A at 120V, 60Hz. That is a very small load, so circuit capacity is almost never the limiting factor on a globe relamp; the practical limit comes from the dimmer or control device rating rather than the branch circuit. Rated life is 15,000 hours.
9) What is the Satco S21225 globe made of?
Glass bulb with a nickel plated aluminum base. The lamp weighs 0.05 lb, which keeps it light enough for delicate pendant and chandelier sockets.
How fast can I get the Satco Lighting S21225 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Satco Lighting S21225 come with a warranty?
Absolutely. The Satco Lighting S21225 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Satco Lighting S21225?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Satco Lighting S21225 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.