SATCO Lighting S39313 7.2W LED Downlight Retrofit, 5-6in, 3000K, 120V, White Finish

Wet location rated, so it holds up in a shower, over a tub, or anywhere water can hit it directly. It also carries a cULus listing, which is the mark most inspectors and facility specs look for on both sides of the border. One limit worth knowing: it is rated as an indoor product, so a covered exterior soffit is outside what the rating covers even though the wet rating would suggest otherwise.

Title 24 compliant, which is the gate on residential and many commercial lighting jobs in California. It is also cULus listed, RoHS compliant, and FCC compliant, so it clears the usual submittal checklist for institutional and multi-family specs.

No. The S39313 is fixed at 3000K, with no CCT selector switch and no wattage selector, so every unit puts out the same 650 lumens of warm white light. That is the point for a fleet: no field switch means no installer setting one hallway to 4000K by mistake. If you want the option to tune color at install, this is the wrong model and you should be specifying a selectable-CCT retrofit instead.

Yes, it dims. It runs on 120 volt, 60 Hz line power, so it is wired to the existing switch leg with no separate low voltage driver to locate. If the room is on an older incandescent dimmer, expect to test one fixture before committing the floor, since LED loads and legacy dimmers do not always track cleanly at the bottom of the range.

The LED is rated for 35,000 average hours. On a corridor or lobby burning roughly 12 hours a day that is about eight years of service, which is the number that decides whether a retrofit pays for the labor of the ladder work. The unit is an integrated LED, not a lamp in a socket, so at end of life the whole retrofit gets replaced rather than relamped.

No junction box work and no new wiring. The retrofit threads into the existing medium base socket in the can and the trim seats against the ceiling, so an in-house maintenance tech can do a unit in a few minutes on 120 volt line power. Satco publishes the installation sheet for the S39313 at https://assets.satco.com/dj18eqo18/image/upload/v1713463030/products/S39313/S39313_Instructions.pdf and the full photometric spec sheet at https://media.satco.com/specsheets/pdf/S39313.pdf.

Aluminum body with a white finish, round shape, 7.40 inches across. Aluminum matters more than looks on a recessed retrofit, since it is the heat path that gets the LED junction temperature out of a closed can. The white trim is the only finish this model is built in, so a fleet of them matches across a ceiling with no finish coordination on the order.