SATCO Lighting S9202 6W, G25 Globe LED, 4000K, Medium Base, 120V

Yes. The S9202 is an enclosed rated lamp, so it can go in a closed vanity globe or a covered fixture without the heat trapping shortening its life. It also carries a damp location rating, which covers a bathroom vanity or a covered porch fixture, but not direct wet exposure.

No on both counts. The S9202 is not DLC listed and is not Title 24 compliant, so it will not satisfy a California Title 24 lighting spec or a rebate program that requires a DLC-listed product. It is FCC compliant.

Yes, it's a dimmable lamp. Use an LED-rated dimmer, since a 6 watt load is well below the minimum load of most older incandescent dimmers and that mismatch is what causes flicker or a dropout at the low end of the dial.

Not as a three-way. The S9202 is a single-level lamp, so in a three-way socket it will light at one output regardless of switch position, or may only come on at certain positions. For a three-way table lamp you need a bulb built for it.

Yes. Burning position is universal, so base up, base down, or horizontal all work. That matters on bath bars and pendant globes where the socket points in whatever direction the fixture was built for.

It spreads. The lamp has a frosted lens with a 175 degree beam spread, so the diode array is diffused rather than visible as points. That is what you want in an open globe fixture or a bare-socket vanity strip where the bulb itself is on show. The body is white.

Each lamp draws 0.050A at 120V, 60Hz. Even derating a 15A circuit to a continuous 12A, the lamp current is not the limiting factor on a relamp of this size; the practical limit will be fixture count and driver inrush, not steady-state load. Rated life is 25,000 hours, which is the number that matters most for a multi-family or hospitality relamp program.