Schaub 5112 12" Center to Center Pub House Cabinet Pull

Yes. The 5112 Pub House pull is drilled on 12 inch centers, so it drops onto an existing pair of holes spaced 12 inches apart. Overall length is 12-1/2 inches, so it only adds about a quarter inch of bar past each post.

It uses #8-32 x 1 inch machine screws, the standard cabinet pull thread. That one inch length covers a typical 3/4 inch door or drawer front. On a thicker slab or if you are stacking a panel, you'll need longer #8-32 screws.

The Schaub 5112 Pub House pull is a solid brass contemporary pull on 12 inch center-to-center spacing with a 12-1/2 inch overall length, which suits tall appliance panels and wide drawers. For narrower drawer fronts, the Omnia 1968/102 modern cabinet pull is forged solid brass on 4 inch center-to-center spacing, and the Deltana SBP35 modern square bar pull is heavy-duty solid brass at 3-1/2 inches. Both keep the solid brass construction while dropping to a boring pattern a small drawer front can accept.

They are not interchangeable. The Schaub 5112 Pub House pull is drilled 12 inch center-to-center with a 12-1/2 inch overall length and mounts with #8-32 x 1 screws. The Trimco 553 series drawer pulls are 3 inch center-to-center and the Trimco 562 series comes in 3-1/2 inch, 4 inch and 96mm center-to-center. None of those hole patterns line up with a 12 inch bore, so swapping one in means redrilling the drawer front.

Projection is 1-1/4 inches from the face of the door, with a 1/2 inch base at each post. That is enough knuckle room for a gloved hand on a tall pantry or appliance panel without the bar standing proud enough to catch in a tight galley.

Solid brass. At 12 inch centers it's the appliance-panel and tall-pantry size in the Pub House collection, and solid brass rather than plated zinc is what keeps a long bar from flexing or snapping at the post under daily pull loads.

The Schaub 5112 Pub House pull projects 1-1/4 inches from the face of the door or drawer. The Omnia 1970 modern cabinet pull is a forged solid brass pull with the same 1-1/4 inch projection, so hand clearance and any adjacent-door swing check carries over. If you need the pull to sit slightly closer to the face, the Omnia 1969 and Omnia 1971 modern pulls are forged solid brass at 1-3/16 inch projection.

The Schaub 5112 Pub House pull is solid brass in a contemporary style, offered in Polished Chrome, Brushed Nickel, Matte Black, Polished Nickel and Signature Satin Brass. If you would rather specify steel for institutional casework, the Orca Hardware CK-12001 T-pull bar is a steel pull with a 2 inch bar width in satin nickel. It is a different look and a different material, so decide whether the brass finish match to the rest of the room matters more than the steel body.

The 5112 needs 12-1/2 inches of clear face, which narrow doors often will not give you. Orca Hardware knobs cover those openings: the Bachelor Collection round cabinet pull knob and round ring cabinet pull knob are both 1-1/4 inch diameter, and the Blackcomb Collection square cabinet pull knob is 25mm. All three are single-hole knobs, so they mount on a door stile where the 12 inch two-hole pattern of the 5112 cannot.

No handing. It's a symmetrical two-post bar pull on 12 inch centers, so it installs horizontally on a drawer or appliance panel or vertically on a tall door with no left or right version to specify. All you choose is the finish.