Schaub 788-12A 12" Center to Center Vinci Appliance Pull

It mounts with 1/4-20 thread screws, which is the heavier appliance-pull standard rather than the 8-32 used on ordinary cabinet pulls. Because panel thickness varies from one appliance to the next, the screw length is what you match to your door, not the pull itself.

Yes. The 788-12A is orderable as a back-to-back set as well as a single pull, in all four finishes: Antique Bronze, Black Bronze, Natural Bronze and Polished White Bronze. Pick the back-to-back option when you need a matching pull on both faces.

The Schaub 788-12A is a rustic-style cast bronze Vinci appliance pull with 12 inch center-to-center spacing. For a contemporary look, the Emtek Bar Cabinet Pull in the Schaub Collection and the Deltana SBP35 Modern Square Bar Pull in solid brass are both bar-profile pulls, and the Omnia 1968/102 is a forged solid brass modern cabinet pull with 4 inch center-to-center spacing. Those are drawer and door pull sizes rather than the long appliance spacing of the 788-12A, so confirm the mounting hole spacing on the appliance panel before substituting.

Projection is 1-3/4 inches, with a 1/2 inch base. That is enough hand clearance for a gloved grip on a refrigerator or range panel, and it is what to check against adjacent walls or a return cabinet before you commit to a 12 inch pull.

The Vinci is a rustic-style cast bronze collection offered in Antique Bronze (AZ), Black Bronze (BB), Natural Bronze (NB) and Polished White Bronze (PWB). Natural Bronze is a living finish that darkens with handling, so if you are standardizing across a kitchen or a run of units, order the appliance pull and the smaller cabinet pulls in the same finish code at the same time.

Emtek offers several Schaub Collection cabinet pulls, including the Emtek 8405 Select, the Alexander, the Art Deco, and the Bar pull, all catalogued as cabinet knob/pull products. The Schaub 788-12A is an appliance pull in the Vinci collection, cast bronze in a rustic style. Mixing them is common when the appliance panel takes the long pull and the doors and drawers take shorter ones, but the Vinci profile and the Emtek series designs are different patterns, so verify finish naming between the two lines before committing a full kitchen.

The Orca Hardware CK-15030 and CK-16030 Bachelor Collection round knobs at 1-1/4 inch diameter and the CK-17025 Blackcomb square knob at 25mm are cabinet knobs with a single fastener, not two-hole pulls, so they cannot land on the 12 inch center-to-center holes of the Schaub 788-12A. The SDC SP50 50MM Spindle is a door control component rather than cabinet hardware. If you need the appliance-panel grip, stay with a two-post pull and match the 12 inch spacing and 1/4-20 thread.

The Schaub 788-12A is cast bronze with a 1-3/4 inch projection. If the job calls for a steel bar instead, the Orca Hardware CK-12001 T-Pull Bar is a steel pull with a 2 inch bar width in satin nickel. Confirm its mounting hole spacing against the 12 inch center-to-center layout the 788-12A uses, since the two are different families.

The Schaub 788-12A projects 1-3/4 inch off the face, which gives a deep hand clearance suited to pulling a heavy appliance panel. The Omnia 1969 and Omnia 1971 forged solid brass pulls each carry a 1-3/16 inch projection and the Omnia 1970 a 1-1/4 inch projection, so they sit closer to the door face. Choose based on the grip clearance the opening needs.