Schaub 788-18A 18" Center to Center Vinci Appliance Pull

1/4-20 thread, which is the heavier appliance-pull thread rather than the 8-32 used on standard cabinet pulls. If you're swapping onto a panel drilled for 8-32 cabinet screws, the holes will need to be opened up. Screw length depends on your panel thickness, so measure the door or drawer front before ordering fasteners.

Back to back means two pulls mounted through the same holes, one on each face of the panel, sharing the fasteners. That's what you order for a glass or pass-through door, or a swinging panel you grab from both sides. For a refrigerator or dishwasher panel where you only touch one face, order the No option. Both configurations are offered in all four finishes.

Four bronze finishes: Antique Bronze (AZ), Black Bronze (BB), Natural Bronze (NB), and Polished White Bronze (PWB). They're living finishes over cast bronze, so Natural and Polished White read brighter and will patina with handling, while Antique and Black Bronze start dark. If you're matching other Vinci collection hardware already in the kitchen, order the same finish code across the run.

The Schaub 788-18A is from the Vinci collection in a rustic style with a cast bronze base material. For smaller cabinet and drawer openings in the same design family, Emtek carries Schaub Collection cabinet pulls, including the Emtek 8405 Select cabinet pulls, the Emtek Alexander cabinet pull, the Emtek Art Deco cabinet pull and the Emtek Bar cabinet pull, all catalogued as cabinet knob/pull function. Those give you a Schaub-collection pull at cabinet scale to run alongside the appliance pull, though each is its own series rather than a smaller Vinci.

The Schaub 788-18A Vinci is a rustic-style cast bronze pull. If the design direction is contemporary, the Omnia 1968/102 modern cabinet pull is forged solid brass with 4 inch center to center spacing, the Omnia 1969 and Omnia 1971 are forged solid brass with a 1-3/16 inch projection, the Omnia 1970 is forged solid brass with a 1-1/4 inch projection, and the Deltana SBP35 is a heavy-duty solid brass modern square bar pull at 3-1/2 inch. All of those are cabinet-scale rather than the 18 inch center to center appliance spacing of the 788-18A, so on an appliance panel you would be drilling a different hole pattern.

Yes, if you need a matched pair through the panel. The Schaub 788-18A Vinci is offered in a back-to-back configuration as well as single-sided, in antique bronze, black bronze, natural bronze and polished white bronze. The cabinet-scale alternatives such as the Trimco 553 Series drawer pulls at 3 inch center to center and the Trimco 562 Series at 3-1/2 inch, 4 inch and 96mm are single-face drawer pulls, so a through-panel pair would have to be assembled rather than ordered as one configuration.

Yes. Schaub publishes a Proposition 65 warning for this product under its product stewardship information. If you're specifying for a California job and need the warning language on the submittal, pull it from Schaub's product stewardship page.

No. A knob is a single-point piece and the Schaub 788-18A mounts on two 1/4-20 posts at 18 inch center to center. The Orca Hardware CK-15030 round cabinet pull knob and CK-16030 round ring knob are 1-1/4 inch diameter, and the CK-17025 Blackcomb square knob is 25mm diameter, all catalogued as cabinet knob function. They fit a single bore on a cabinet door or drawer and cannot pick up the two-hole appliance panel spacing the 788-18A uses.