Schlage A Series 10-027 Full Lip Strike, 1-5/8" x 2-1/4", 1/4" Round Corner

Yes. The 10-027 full lip strike is a Schlage replacement part for the A Series, and it also fits the CS210 and S200 locks. If you're replacing a strike on an A Series cylindrical knob set, this is the matching part rather than a generic strike.

The 10-027 measures 1-5/8 by 2-1/4 inches with 1/4 inch radius corners, so it drops into a frame already routed for a standard 1-5/8 x 2-1/4 strike prep with round corners. If your existing frame cutout is square-cornered or the common 1-1/4 x 4-7/8 T-strike prep, this plate won't cover it and you need a different strike.

A full lip strike has the extended curved lip that wraps past the frame edge, so the latch rides up the lip and retracts as the door closes. That is what you want on a standard wood or hollow metal jamb where the door face sits proud of the stop. A flat, lipless plate only suits deep-recessed or double-rabbeted conditions where a lip would foul the door. The 10-027 is the full lip version.

Ten finishes: 605 bright brass, 609 antique brass, 612 satin bronze, 613 oil rubbed bronze, 619 satin nickel, 620 antique nickel, 622 matte black, 625 bright chrome, 626 satin chrome, and 643E aged bronze. Schlage strike parts are finish specific, so order the same BHMA number as the lockset on the door rather than eyeballing the color, especially across the bronze and nickel families where 612, 613 and 643E read very differently in daylight.

It's a commercial-rated Schlage part in stainless steel, which is the reason to use it over a plated steel strike on a high-cycle opening: the lip takes the latch impact every close and stainless holds its edge and finish without rusting at the jamb. For apartment corridors, offices, and other doors cycling all day, it's the right substrate.

Yes, provided the openings are running Schlage A Series, CS210, or S200 locks and the frames are prepped 1-5/8 x 2-1/4 with round corners. Buying one model in one finish across the property means a maintenance tech carries a single part for every door instead of matching plates one at a time. Openings with a different lock line or a different frame prep still need their own strike.

Genuine Schlage. The 10-027 is a factory replacement strike, so the lip profile, screw hole spacing, and finish coding follow Schlage's own A Series standard rather than an approximation of it. That matters most on the finish, since an aftermarket 626 rarely matches a Schlage 626 sitting next to it on the same jamb.

No handing to specify. The 10-027 is symmetrical top to bottom, so the same plate serves a left hand or right hand opening; you just orient the lip toward the door swing when you set it. Only the finish and the frame prep have to match.