Shop All Metallics

Carbon Steel Tap Bottoming Type 7/16-14 (1pc)

Carbon Steel Tap Taper Type 7/16-14 (1pc)

Carbon Steel Tap Plug Type 7/16-20 (1pc)

Carbon Steel Tap Taper Type 7/16-20 (1pc)

3/4 K-O Seal & Gasket USA 316 SS

3/4" SS KO SEAL & Gasket ET w/ WI

Anchors Sleeve Hex Head 3/4" x4-1/4" Bolt 5/8" (Jar 50)

Straps 1-Hole X 3/4 EMT Conduit Stp (Box 100) Additional Notes Other sizes and quantities available by request

Strap 2-Hole X 3/4 EMT Conduit Stp (Box 100) Additional Notes other sizes and quantities available by request

Seal 3/4" K-O Seal &Gask St-zn (10)

Gasket 1-1/6 x 1-3/8 Gask NPRN(1pc)

Straps 1-Hole X 3/4 Rigid Conduit Str (Box 100) Additional Notes Other sizes and quantities available by request

Strap 2-Hole X 3/4 Rigid Conduit Stp (Box 100) Additional Notes other sizes and quantities available by request

Seals 3/4 Snap-In K-O St-zn (Bag 10) Additional Notes other sizes and quantities available by request

Carbon Steel Tap Bottoming Type 7/8-14 (1pc)

Carbon Steel Tap Taper Type 7/8-14 (1pc)

Carbon Steel Tap Bottoming Type 7/8-9 (1pc)

Carbon Steel Tap Taper Type 7/8-9 (1pc)

8 x 1 in. Flat Head Phillips Wood Screws - Steel Zinc - 100qty Additional Notes Other sizes and quantities available by request | Length of Thread: Length = 1 inch then 2/3 thread Features Steel Zinc Material Screws of nominal lengths too short to...

8 x 1 in. Pan Head Phillips Sharp Point Tapping Screws - Steel Zinc - 100qty Additional Notes Other sizes and quantities available by request | Dimensions for #9 diameter are independent of ASME B18.6.4 Features Steel Zinc Material Pan head with...

8 x 1 in. Wafer Head Phillips Sharp Point Drywall Screws - Steel Zinc - 100qty Features The head design offers low clearance and an extra large bearing surface. 8 Diameter, 1" Length Steel Zinc Material Eliminates need for pre-drilled or pre-punched...

8 x 1-1/4 in. Pan Head Phillips Sharp Point Tapping Screws - Steel Zinc - 100qty Additional Notes Other sizes and quantities available by request | Dimensions for #9 diameter are independent of ASME B18.6.4 Features 8 Diameter, 1-1/4" Length Steel...

8 x 1/2 in. 1/4 Indented Hex Head Self-Drilling & Tapping Screws with Washer - #2 Drill Point - Steel Zinc - 100qty Features Minimum torques are the same for stainless and steel self-drill screws. Drill time is 2.5 seconds for a 1 mm thick plate. 8...

8 x 1/2 in. Pan Head Phillips Sharp Point Tapping Screws - Steel Zinc - 100qty Features Pan head with Phillips Drive Steel Zinc Material 8 Diameter, 1/2" Length Additional Notes Other sizes and quantities available by request | Dimensions for #9...