Ty-Duct TYD15X4NPG6 1.5X4 NARROW SLOT GRAY DUCT

Each stick of the TYD15X4NPG6 narrow slot duct runs 6 ft (1.83 m). It is sold by the foot, so order quantity against your total run length and plan your cuts around the 6 ft stick.

No adhesive backing on the TYD15X4NPG6. It mounts mechanically, so plan on screws or rivets through the duct base into your backpan, subpanel, or wireway surface. If you want peel-and-stick mounting, you need a duct ordered with adhesive tape backing instead.

Narrow slot duct, which is what the TYD15X4NPG6 is, has tighter finger spacing and smaller slot openings. That holds small conductors and control wire in place better and keeps wires from bowing out between fingers, which is why it gets used in control panels and terminal block routing. Wide slot duct is the better pick when you are dropping in larger bundles or heavier gauge power conductors and want easier entry and exit at each breakout point.

It is PVC in gray, the standard color for panel wiring duct, so it sits in with existing gray duct runs on a subpanel or backpan without looking patched. PVC also means you cut it with a fine-tooth saw or duct cutter rather than tin snips.

The 1.5 x 4 designation in the TYD15X4NPG6 is the duct cross section, so you are getting a tall, deep channel rather than a shallow one. Check your panel layout clearances before committing: a 4 inch dimension eats real estate between DIN rails and terminal strips, and in tight enclosures a 1.5 x 3 or 1.5 x 2 profile is often the better fit.

Yes. The TYD15X4NPG6 plastic wiring duct carries a United States country of origin, which matters on government, institutional, and Buy American specified jobs where domestic sourcing has to be documented in the submittal.