B-Line 10250T3532 30.5 mm, Heavy-Duty Assembled Control Station

It's a three-element assembled pushbutton station legended FOR REV STOP, so it drives a reversing motor starter: forward, reverse, and stop. All three actuators are flush pushbuttons, black and red, and all operate momentary, so the station signals a starter or control relay to latch rather than holding the circuit itself.

Yes. The enclosure carries NEMA 4, 4X, 12 and 13 ratings, which covers hosedown and washdown duty, corrosive environments (4X), and dust, oil and coolant exposure (12/13). The housing is die cast. It mounts on the surface, so run conduit to it rather than planning a flush cutout.

The station comes wired with a 2NO-3NC contact arrangement across the three operators. That gives you a normally open contact for each of forward and reverse, a normally closed stop contact, and two more normally closed contacts, which is the usual arrangement for mechanically cross-interlocking the two directions in a reversing control circuit. Verify against your ladder before you land wires.

No. All three operators are momentary flush pushbuttons, so the stop button breaks the circuit only while it's pressed and the starter drops out. That is a control stop, not a maintained push-pull or twist-release emergency stop. If your machine needs a latching E-stop, specify a 30.5 mm maintained mushroom-head operator instead of relying on this station.

It's built on the Eaton/B-Line 10250T heavy-duty 30.5 mm platform, so the operator holes are the industry-standard 30.5 mm size used across that line. Replacement flush pushbutton operators and contact blocks from the same 30.5 mm heavy-duty family drop into the existing holes.

It ships assembled: die cast enclosure, three flush pushbutton operators already fitted and legended FOR REV STOP, with the 2NO-3NC contacts in place. You supply the mounting hardware for the surface it lands on, the conduit and fittings, and the field wiring to the starter.

Flush actuators sit level with the guard ring, which makes accidental operation less likely, a reasonable choice where the station is mounted at hand height on machinery or where operators wear gloves and might brush past it. If you need the stop to be findable by feel or hit fast, an extended or mushroom-head stop operator is the better pick, and this station does not offer one since all three of its elements are flush.

Order it as B-Line 10250T3532. That single part number covers the assembled three-element 30.5 mm heavy-duty station with the FOR REV STOP legend, black and red flush buttons, and 2NO-3NC contacts.