You may also like
Anchors 1/2 X 7 Wedge Ancr St-zn M (Box 25)
Manufacturer Resources
Product Specs
- Division:
- Electrical H1
- Pack Type:
- Box
- Product Group:
- Fasteners
- Sub Division:
- Electrical-E H2
- Department:
- Electrical
- Product Subgroup:
- Anchors
Metallics TS407D – Frequently Asked Questions
1) Will a 7 inch long wedge anchor work for mounting conduit strut or equipment to a concrete slab?
A 1/2 x 7 inch wedge anchor is a long-shank anchor, so most of that 7 inches is meant to go into the concrete. Subtract the thickness of the strut, channel, or base plate you are fastening plus the nut and washer, and the rest is your embedment. For thin material like a strut channel fastened flat to a slab, 7 inches is more anchor than you need and you will have excess thread standing proud; a shorter 1/2 inch wedge anchor suits that. The 7 inch length pays off when you are going through thick grout, a topping slab, a sill plate, or a heavy equipment base.
2) What base material are Metallics wedge anchors made for?
Wedge anchors like the TS407D are for solid concrete only. They work by a clip expanding against the wall of a drilled hole, which needs the uniform strength of poured concrete. Do not use them in hollow block, brick, mortar joints, or stone; those call for a sleeve anchor, a screw anchor rated for masonry, or an adhesive anchor with a screen tube.
3) Is the Metallics TS407D wedge anchor zinc plated or stainless?
Zinc plated carbon steel, not stainless. That finish is for dry interior or protected work. For exterior, wet, or corrosive locations, step up to a hot dip galvanized or stainless steel wedge anchor instead.
4) Do I need anything else to install the TS407D wedge anchor?
Each wedge anchor ships with its own nut and washer assembled on the threaded end, so no separate hardware is needed to make the connection. On the job you still need a hammer drill with a 1/2 inch carbide bit, a blow-out bulb or vacuum to clear the hole, a hammer to drive the anchor, and a wrench or impact to pull the nut up and set the wedge.
5) How do I order the Metallics 1/2 x 7 wedge anchor by part number?
Order by Metallics part number TS407D. That is the 1/2 x 7 inch zinc plated steel wedge anchor in the 25 piece box, and it is the only configuration under that number, so there is no diameter, length, or finish option to specify.
How fast can I get the Metallics TS407D delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Metallics TS407D come with a warranty?
Absolutely. The Metallics TS407D is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Metallics TS407D?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Metallics TS407D from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.