Metallics TS5051SSD Anchors 12...
IN STOCK (leaves warehouse same day if ordered before 3pm ET)
$148.41
$98.57

Metallics TS5051SSD Anchors 125 5/8 x 5 Wdg SS (Box 25)

(No reviews yet) Write a Review

Model: TS5051SSD
Selected Model is

In Stock (leaves warehouse same day if ordered before 3pm ET)

$148.41
$98.57
Adding to cart… The item has been added
Free Shipping on orders over $199
We price match and offer bulk discounts! Click Add to Quote. It's quick and easy.
✨
Earn points with this purchase! You can redeem points for giftcards, iPads, XBox's and more. View Rewards
Free Keying on all locks
Anchors 125 5/8 x 5 Wdg SS (Box 25)

Manufacturer Resources

Product Specs

Division:
Electrical H1
Pack Type:
Box
Product Group:
Fasteners
Sub Division:
Electrical-E H2
Department:
Electrical
Product Subgroup:
Anchors

Metallics TS5051SSD – Frequently Asked Questions

1) Will a wedge anchor work in block or brick, or only in concrete?
Wedge anchors are for solid, cured concrete. In hollow CMU, brick, or grout-filled block the expansion clip does not get consistent bearing, and in hollow cells it has nothing to grab at all. For those bases use a sleeve anchor, a screw anchor rated for masonry, or an adhesive anchor with a screen tube instead of the TS5051SSD.
2) Can I use a stainless wedge anchor outdoors or in a wet area?
Stainless is the reason to pick this one. The TS5051SSD is a stainless steel wedge anchor, so it suits exterior, damp, and washdown locations where a plain zinc-plated carbon steel anchor would rust and lose holding value. Typical uses are anchoring exterior equipment pads, rooftop curbs, railings, and strut or conduit supports into cured concrete.
3) Can a wedge anchor be removed or reused once it's set?
No. The clip on a 5/8 x 5 wedge anchor expands permanently against the hole wall, so once it is set the anchor stays. You can back the nut off and remove the fixture, but the stud remains. If you need a removable fastener for equipment that gets pulled and re-set, use a female-threaded drop-in anchor or a threaded insert rather than this one.
4) Do wedge anchors come with nuts and washers?
Wedge anchors in the TS5051SSD style ship as a complete assembly: the threaded stud with the expansion clip, plus the hex nut and washer needed to set it. No separate hardware purchase is required, though you will need a carbide hammer-drill bit and a torque wrench or impact to pull the anchor up against the clip.
5) Should I mix stainless anchors with galvanized strut and fittings?
Watch the metals. The TS5051SSD stud is stainless steel, and pairing stainless fasteners with plain galvanized or carbon steel channel in a wet exterior location sets up galvanic corrosion at the joint. For outdoor runs, carry the stainless through the strut, channel nuts, and clamps as well, or isolate the connection.
How fast can I get the Metallics TS5051SSD delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the continental U.S. Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit, reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Metallics TS5051SSD come with a warranty?
Absolutely. The Metallics TS5051SSD is backed by a manufacturer’s warranty. For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Metallics TS5051SSD?
You can call, text, or email our expert support team for fast answers. We’re here to help with product selection, installation tips, and troubleshooting. Contact Us
Why buy the Metallics TS5051SSD from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support, and rewards on every order. Our team is always ready to help you choose the right product for your project.