B-Line Eaton series Flex tray wire basket tray, Limited industrial and interior, Pre-galvanized zinc, Steel, 31.5" actual area inside tray, 2" deep fl

No. The FT2X8X10 GS is steel with a pre-galvanized zinc finish and is rated for limited industrial and interior use. Pre-galvanized coating is applied to the sheet before fabrication, so cut ends and welds have only the sacrificial protection of the surrounding zinc. For exterior runs, damp plenums, or corrosive/wash-down environments you want a hot-dip galvanized after fabrication or stainless basket tray instead.

Basket tray such as the 2 inch deep Flextray is the usual pick for low-voltage and data cabling: the open mesh lets you drop cable in anywhere along the run, gives free airflow for heat dissipation, and lets you see the bundle for moves and adds. Solid-bottom or ladder tray is the better answer where you need physical shielding of the cable, EMI containment, or long unsupported spans carrying heavy power feeders. At 8 inches wide with 31.5 square inches of fill area inside, this size suits a moderate riser or horizontal backbone rather than a main data center trunk.

What you get is the tray section itself, 8 inches wide by 2 inches deep, in a 118.312 inch length. Splice connectors, wall brackets, trapeze or center-hung supports, threaded rod, and any grounding hardware are separate line items and need to be ordered alongside the tray to complete the run.

Yes, that is the point of wire basket tray. The steel mesh is cut with a bolt cutter or tray cutter and formed by hand into 90s, offsets, and tees without ordering factory fittings. One caution with the pre-galvanized finish: cutting exposes bare steel at the wire ends, so in any damp or industrial location touch the cuts up with a cold galvanizing compound, and file them smooth so they don't nick cable jackets.

The Flextray FT2X8X10 GS is CE marked. That is the certification held on record for this part number; specify it where a CE declaration is called out on the submittal.