B-Line Eaton series ground mounted panel enclosure, 60" height, 20" length, 60" width, 4, Hinged cover, ES4 enclosure, Ground mount, Large double doo

The ES4 enclosure carries a NEMA 4 rating, so it is built to keep out windblown dust, rain, splashing water and hose-directed water. Sealing comes from a closed cell neoprene gasket on the hinged cover. NEMA 4 does not include the corrosion resistance of a 4X, so for salt spray or washdown chemical exposure you want a stainless or non-metallic 4X box instead of this painted carbon steel one.

60 inches high, 60 inches wide and 20 inches deep. That is a large double door footprint, so allow clearance in front for both doors to swing fully and for the 3-point latching handle sweep before you set the pad.

No. The ES-606020-4 ships with no mounting provisions inside, so there is no back panel, no rails and no pre-drilled holes for equipment. Order the subpanel or mounting kit separately and plan your own hole layout in the 12 gauge carbon steel body.

It is a ground mount design, meant to sit on a concrete pad or foundation rather than hang off a wall. At 472.4 lb empty, wall mounting is not the intended method for this box. Set and anchor it to the pad, then bring conduit in through holes you cut in the field. If you need a wall hung box, choose a wall mount NEMA 4 enclosure instead.

It is built to UL 508A, the standard for industrial control panels, so it is an acceptable housing for a control panel build feeding motors, drives or PLC gear. Combined with the NEMA 4 rating it suits outdoor control panel installations.

The seal depends on the closed cell neoprene gasket at the hinged cover and on how you finish your penetrations. Since the box ships with no mounting provisions or factory holes, every entry you cut in the 12 gauge steel must use a NEMA 4 rated watertight hub or fitting to keep the rating. An untreated hole or a standard locknut connector drops the enclosure below NEMA 4.

Yes. The enclosure has a key lock padlock provision and a 3-point latching handle, so the double doors pull tight at three points and can be secured with a padlock through the handle provision. That covers most utility and municipal site requirements for a lockable ground mounted panel.

472.4 lb empty. Plan on a forklift, boom truck or crane pick to place it, plus rigging, and account for the added weight of gear once the panel is populated when you size the pad. This is not a two-man set.

The manufacturer part number is ES-606020-4, an ES4 series enclosure from Eaton's B-Line business, made in the US. The number reads out as the size: 60 high, 60 wide, 20 deep, NEMA 4.

Painted ANSI 61 Grey, which is the standard grey used across most industrial switchgear and control enclosures, so it will read the same as existing ANSI 61 equipment on site. The finish is over 12 gauge carbon steel.