B-Line Eaton series ground mounted panel enclosure, 60" height, 24" length, 60" width, 4, Hinged cover, ES4 enclosure, Ground mount, Large double doo

The ES4 enclosure carries a NEMA 4 rating, so it handles outdoor duty including rain, splashing water and hose-directed water. The seal comes from a closed cell neoprene gasket behind the hinged cover, and the carbon steel body is painted ANSI 61 grey. It is a ground mounted cabinet, so it sits on a pad or frame rather than hanging off a wall.

60 inches high, 60 inches wide and 24 inches deep, built as a large double door style cabinet. It weighs 504.4 lb, so plan on rigging or a lift and a prepared pad or floor stand rather than two people carrying it into place.

It is built to UL 508A, the standard for industrial control panels, which is what a plan reviewer or AHJ looks for when the cabinet houses motor starters, drives or PLC gear. The 12 gauge carbon steel wall thickness goes with that heavier control panel duty.

Both doors are hinged and secured by a 3-point latching handle, which pulls the door tight against the gasket at top, middle and bottom. The handle has a key lock and padlock provision, so you can pin it for a utility or maintenance-only opening without adding aftermarket hardware.

At 60 inches wide, a single swinging door needs 60 inches of clear space in front of it and gets heavy to handle. The double door arrangement on the ES4 splits that swing in half, which matters in a tight equipment yard or mechanical room aisle, and gives you full-width access across the 60 x 60 inch face for pulling conductors and mounting wide gear.

There are no factory mounting provisions in this ES4 cabinet, and the enclosure is supplied as a sealed 12 gauge carbon steel box with a gasketed hinged cover. Any conduit entries get field-cut, and to hold the NEMA 4 rating every penetration needs a watertight hub or fitting rated to match.

The ES-606024-4 body is painted carbon steel, which suits general outdoor and industrial service under its NEMA 4 rating. For salt spray, chemical washdown or coastal exposure, a stainless enclosure carrying NEMA 4X is the right call instead, since 4 alone does not cover corrosion resistance.

Yes, country of origin on the ES-606024-4 is the US, which is what matters if your project carries a domestic sourcing requirement on government or federally funded work.