B-Line Eaton series meter s, 100 A, Single meter position, Ring type, 3R, Underground, ANSI 61 gray painted, 010 kAIC, #14 - 1/0, MCB, 100 A, 2P, Gal

Yes. The U1M1R7 is a 3R rated enclosure built for underground service entrance, surface mounted, in galvanized steel with an ANSI 61 gray painted finish. The 3R construction is what lets it live on an exterior wall, and the underground configuration means the service conductors come up into the can from below rather than an overhead weatherhead drop.

One meter position only. It is a 7 jaw, 4 wire socket wired for 3 phase 120/240 V service. If you need to meter two or more tenants off one service, this single position can will not do it, and if your utility meters a single phase 3 wire residential service you want a 4 jaw socket instead, not this one.

Ring type. The meter is retained by a sealing ring rather than a ringless cover, so confirm your serving utility accepts ring type sockets before ordering. Utilities are specific about this and a ringless jurisdiction will reject a ring type can at inspection.

The main is included. It ships with one 100 A, 2 pole main circuit breaker matched to the 100 A rating of the can, so this is a meter main combination rather than a bare meter socket. You do not order the main separately.

The U1M1R7 is rated 10 kAIC at 120/240 V. That covers most residential and light commercial services fed from a small utility transformer. If your utility's available fault current letter puts the service above 10 kA at the meter, this unit is not code compliant for that location and you need a higher AIC assembly.

Yes, the U1M1R7 is EUSERC approved and UL listed. EUSERC approval is what most western utilities require before they will set a meter, so this is the box to specify on those jobs.

The unit is rated for conductors from #14 up to 1/0, which covers typical 100 A service entrance copper and aluminum sizing. Bus is aluminum, so use an antioxidant compound and torque to the label values when terminating aluminum conductors.

It measures 24 in high, 14 in wide and 4.625 in deep, and weighs 30 lb. That depth is shallow enough for a surface mounted exterior wall with standard blocking, and the 30 lb weight is a one man hang.

This is a meter socket with a single 100 A, 2 pole main, not a loadcenter. There are no branch breaker spaces in it, so you land the load side on a feeder and run to a separate panelboard for your branch circuits.