Command Access PD15/16 Complete Motorized Storefront Exit Device for Kawneer 1686/1786 & Jackson 1285/1295 Retrofit

PD15/16 Series

Complete Motorized Storefront Exit Device for Kawneer 1686/1786 & Jackson 1285/1295 Retrofit

-The Command Access PD15-M series is a motorized latch pullback Grade 1 storefront exit
device; made for use in all institutions and commercial buildings storefront applications.
All PD15-M models are equipped with our PTS “push to set” technology. As a retrofit for the
Jackson 1285/95 & Kawneer 1686/1786 series models are designed to utilize the existing
mounting locations and mortise or rod & case assemblies without having to remove the door.
Install this device with the confidence of knowing that the PD15-M series meets or exceeds the
high standards of other grade 1 products and carries our 3-year “no hassle “ warranty, meaning
we will support you

Features

• Next Generation MM4 Smart Module: On boarddiagnostics with audible feedback for adjustmentand power issues
• "PTS": 5 second electronic adjustment for easypost installation adjustment
• Electric dogging rated for continuous duty - Autore-engage if push pad is pulled from dogged position.
• Low Current Draw - Field switchable to a "LowCurrent" or "High Torque" mode.
• Up to 300' wire run with 2-18ga wire - Long wireruns provides installer with convenience of placingthe Command locking hardware power supply ina centralized location; i.e. the same closet as the access control panel.
• 8' cable with Quick Connect for MM4 module toeasily connect to power supply lead.
• UL listed
• 3 Year No Hassle Warranty

Specifications

Electronics:

• System protection – unit shutdown when voltage exceeds 28VDC
• Standard - Average Current Peak: 1.3A, Average Current Hold: 170mA
• High Torque - Average Current Peak: 2A, Average Current Hold: 250mA
• PTS adjustment – approx. 1/4”
• 300’ Run w/ 18ga

HARDWARE

Handing

• RIM device is non-handed. CVR device is handed.

Push Bar Lenght

• Standard sizes: dimensioned for 36” and 48” openings. Standard width bars can be field cut to the next smallest opening width.

Door Thickness

• Suits 1-3/4” standard

Projection

• 2-5/8” when fully projected, 1-5/8”when dogged.

Stile Width

• Minimum 2” Stile. Fits narrow, medium, and wide stile aluminum doors.

Dogging

• Standard dogging with hex key or cylinder dogging option. Electric dogging also available.

Fasteners

• Standard self-tapping screws

Vertical Rods

• Top and bottom steel rods for easy adjustment
• Standard device is adjustable for nominal door heights

PD15-M Cutsheet

Installation Instructions