B-Line D80JE10A D80 Series ON Delay Pneumatic Timer

Yes. The D80 Series ON or OFF delay timers are field convertible from ON to OFF, or OFF to ON, by rotating the solenoid assembly 180 degrees. The timing function is marked on the mounting plate, so after you rotate it you can confirm which mode the unit is set to. The D80JE10A ships configured as an ON delay timer.

Timing is adjustable from 0.5 to 180 seconds on the D80JE10A, so one unit covers everything from a half second anti-short-cycle delay up to a three minute sequencing delay. No need to stock separate short and long range timers for jobs in that band.

Yes. The D80JE10A coil is rated 110/120V and the unit is rated for 50-60 Hz, so it drops onto a typical 120V AC control circuit in North America and works equally on 50 Hz systems for export panels.

The D80JE10A carries a 1NO-1NC timed contact set, one normally open and one normally closed, both operating at the end of the delay. It also includes an auxiliary contact assembly, which is what you use when you need a contact that follows the coil immediately rather than waiting out the delay.

A pneumatic timer such as the D80JE10A does its timing mechanically with an air dashpot, so there is nothing to program and the setting is a dial you can see and adjust on the panel. That suits motor starter sequencing and anti-short-cycle duties where the delay is set once and left alone, anywhere in the 0.5 to 180 second range. Electronic timing relays are the choice when you need sub-second repeat accuracy, multiple timing functions in one device, or delays longer than three minutes.

No. The D80JE10A comes with the auxiliary contact assembly, so you are not adding a separate line item for it. The timed side is 1NO-1NC.

The part number is D80JE10A. That is the D80 Series ON delay pneumatic timer, 110/120V coil, 1NO-1NC timed contacts, with the auxiliary contact assembly included.