B-Line D80JE10E D80 Series ON Delay Pneumatic Timer

Yes. The D80 Series ON or OFF delay timers convert in the field by rotating the solenoid assembly 180 degrees, so a D80JE10E shipped as an ON delay unit can be set up as an OFF delay without ordering a different part. The timing function in use is shown on the mounting plate, so the next person in the panel can see how it is set without pulling it apart.

The D80JE10E carries a 208-220V coil. That covers 208V and 220V control power. If your panel runs 120V or 480V control, this is the wrong catalog number and you need the D80 timer built for that coil voltage instead.

Timing is adjustable from 0.5 to 180 seconds, so it covers everything from a half second anti-chatter delay up to a three minute sequence. Anything longer than three minutes needs a different timing head or an electronic timer.

One normally open and one normally closed contact, both timed. That is enough to start one circuit and drop another on the same delay. If you need instantaneous contacts alongside the timed ones, or more than two poles, you are looking at a different D80 contact arrangement.

A pneumatic timer such as the D80JE10E sets its delay mechanically off a solenoid and air dashpot, and the setting is adjusted on the unit rather than programmed. It suits motor starter and control panel sequencing where you want one fixed, repeatable delay in the 0.5 to 180 second window and no firmware to configure. Go electronic if you need multiple timing functions in one device, long delays past three minutes, or digital setpoints.

Order it as D80JE10E, the B-Line D80 Series ON delay pneumatic timer with a 208-220V coil and one timed NO plus one timed NC contact. That full combination is what the single catalog number covers.