Deltana UFBD5000 Round Universal Floor Door Bumper Dome Cap 2-1/8", Solid Brass

The UFBD5000 is a low round dome cap 2-1/8 inch across, so it only reaches a door bottom that sits close to the floor. Where the door bottom is higher, a taller riser is the better pick: the Delaney Gooseneck Floor Door Stop (40118X), the Emtek 2253 Goose Style Door Stop, or the Orca Hardware 22HD Series goose neck floor stop. Cylindrical risers are another route - the Emtek 2257 is a 1-1/2 inch cylindrical floor bumper and the Sure-Loc DS-FL2 is a cylindrical floor stop for residential doors.

The Deltana UFBD5000 is a floor bumper only - it stops the door, it does not latch it open. For hold-open duty, look at the Ives FS40 / FS41 / FS42 / FS43 automatic floor stop and holder, the Orca Hardware 22HD Series goose neck floor stop, which is catalogued as a door holder and fits 1-3/8 inch or 1-3/4 inch doors, or the SOSS MDH magnetic door holder and stop at 3-5/16 inch by 1-3/4 inch.

The Deltana UFBD5000 is a round universal floor door bumper with a 2-1/8 inch dome cap in solid brass. The nearest same-shape alternatives are the Delaney Dome Door Stop (40260X) and the Emtek 2251 Half Dome Door Stop, both dome-profile floor stops, and the Orca Hardware 23LP Series dome floor stop, which is a low-rise dome with a gray tip. For a brass dome stop in a heavy-duty line, the Ives FS17 is a heavy-duty brass floor dome stop with a rubber bumper.

The Deltana UFBD5000 is a solid brass floor bumper designated for commercial use. If your spec calls out a heavy-duty rating, the Ives dome stops carry a heavy duty duty level: the FS17 is a brass floor dome stop with a rubber bumper and the FS13 is a brass floor dome stop with a replaceable rubber bumper, which lets maintenance renew the contact surface without pulling the base. The Ives FS18S/FS18L security floor stop is also heavy duty and is the choice where tamper resistance is part of the requirement.

Solid brass throughout, and Deltana rates the UFBD5000 for commercial use. Brass is the usual choice for floor stops in corridors and entries because it takes repeated door strikes without deforming and does not rust in a wet vestibule. For openings taking very heavy abuse, the Ives FS13 and FS17 brass floor dome stops are catalogued as heavy duty.

A dome bumper sits low on the floor and takes the door on its face, so it works where the door needs to stop well inside the room and you want minimal projection off the floor. A gooseneck rises off the floor and contacts higher up the door, which suits doors with a large undercut or where a low dome would be missed entirely, and gooseneck versions often double as holders. In the gooseneck style ZenSupply carries the Delaney Gooseneck floor door stop, the Emtek 2253 goose style, and the Orca 22HD. Dome alternatives include the Delaney Dome Door Stop, the Emtek 2251 half dome, and the Orca 23LP low rise dome.

Yes. The UFBD Series universal floor bumpers are produced in a range of finishes, so the dome cap can be specified to match existing brass lever sets, hinges, and kick plates across a fleet of openings. The UFBD5000 itself is the 2-1/8 inch round model.

No. The UFBD5000 is a standard round brass dome bumper, not a security stop. For detention, behavioral health, or any area where the stop gets attacked, the Ives FS18S/FS18L security floor stop is the purpose-built option.

Two things get ordered by mistake against the UFBD5000, which is a 2-1/8 inch round dome floor bumper. First, the hold-open devices: the Ives FS40 / FS41 / FS42 / FS43 automatic floor stop and holder and the SOSS MDH magnetic door holder and stop both retain the door rather than simply stopping it. Second, the small-diameter bumpers - the Emtek 2254 floor door bumper measures 1-3/8 inch by 1-1/4 inch, a noticeably smaller footprint than the 2-1/8 inch Deltana cap, so it will not cover the same floor mark on a replacement.

The UFBD5000 is a solid brass commercial floor bumper. On apartment and single-family doors where a brass dome is more than the opening needs, the Sure-Loc DS-FL1 floor stop with spring and modern door stop designs and the Sure-Loc DS-FL2 cylindrical floor stop for residential doors are both aimed at residential openings, and the Delaney Dome Door Stop (40260X) keeps the dome profile in a lighter residential line.

The UFBD5000 is supplied as a solid brass round dome cap in the 2-1/8 inch size. If a field-replaceable bumper is a requirement for your maintenance program, the Ives FS13 brass floor dome stop is catalogued specifically with a replaceable rubber bumper.

Sold each. The unit of measure on the UFBD5000 dome cap is one piece, so if you are standardizing a corridor or a run of apartment doors, order one per opening.