B-Line Eaton series Grip Strut three diamond plank, 120" Grating length, 7" Grating width, Steel, 2" Channel size, Mill-galvanized, Grip Strut, 10 gau

The Grip Strut three diamond plank, model 32010 10 GL, is a 10 foot piece: 120 inches long by 7 inches wide, with a 2 inch channel height. That 7 inch width is the walking surface of one plank, so a wider walkway is built by laying planks side by side rather than by cutting one down. The 2 inch channel depth is what you need to allow for in your support framing.

Yes. The B-Line Grip Strut three diamond plank is listed as OSHA compliant, and the three diamond perforated surface is what makes it an anti-slip walking surface for platforms, catwalks and access ways where sure footing is required.

The 32010 10 GL plank is steel with a mill-galvanized finish, meaning the coil was galvanized before forming, so the cut and punched edges are raw steel. It handles covered exterior and industrial interior duty well. For continuous weather exposure, heavy wash-down, or corrosive chemical areas, specify a hot-dip galvanized-after-fabrication or stainless plank instead.

It's formed from 10 gauge steel, the heavier end of the Grip Strut range, and one 10 foot plank weighs 9.5 lb. That's a one-man lift, so a crew can stage a run of planks by hand without rigging.

Grip Strut is a single piece of perforated, formed steel with diamond openings punched up to create serrated traction edges in every direction, and it comes as a ready-to-set plank, in this case 120 by 7 inches with 2 inch turned-down channel sides. Bar grating is a welded assembly that carries heavier point loads over longer spans but gives you a flat bar edge to walk on rather than a gripping surface. For personnel access ways, stair treads and service platforms where slip resistance is the driver, the Grip Strut plank is the usual pick.

The 32010 10 GL is supplied as the plank alone. Hold-down clips, saddle washers, bolts or weld attachment to your supports are ordered separately, so budget the attachment hardware and the supporting steel as part of the job.

Reorder by Eaton B-Line part number 32010 10 GL. That number locks in the three diamond plank pattern, 120 inch length, 7 inch width, 2 inch channel, 10 gauge steel and mill-galvanized finish, so replacement pieces match what is already installed.