B-Line Eaton series imperial cable tray and ladder, 6" Height, 14.692" Length, 30" Width, Series 2-5 vertical inside bend, Aluminum, 30° Angle, 12" Ra

A vertical inside bend changes the elevation of a cable tray run where the tray turns upward toward the inside of the angle, typically where a run rises to clear an obstruction or drops to a panel. The Eaton B-Line 6A-30-30VI12 is a Series 2-5 vertical inside bend with a 30 degree angle and a 12 inch radius, so it carries the run through a 30 degree elevation change. If your run needs to bend the other direction, over the outside of the angle, you need a vertical outside bend instead, not this fitting.

Allow for the fitting's 14.692 inch length along the run, plus the 12 inch inside radius of the turn. On a congested ceiling that radius is the number that decides whether the bend clears the duct or beam you are routing around, so lay it out before you cut the adjoining straight sections.

The 6A-30-30VI12 vertical inside bend carries CSA certification, which is the listing Canadian electrical inspectors look for on cable tray fittings.

Order splice connectors and hardware separately. The 6A-30-30VI12 is the bend fitting itself, a Series 2-5 vertical inside bend in aluminum, and you will need matching splice plates at each end to tie it to the adjoining straight sections, plus supports sized to the load at the elevation change.

The manufacturer part number is 6A-30-30VI12 from Eaton's B-Line series. Read it as 6 inch rail height, 30 inch width, 30 degree angle, vertical inside, 12 inch radius, which is how the rest of the family is numbered too.