B-Line B409-14ZN Eaton series strut fittings and accessories, 4.62" Height, 14" Length, 1.62" Width, 2.74lbs, Steel, Single channel bracket, Uniform load capacity 800 lbs, Electro-plated zinc

The B409-14ZN single channel bracket carries a uniform load rating of 800 lbs. That is a uniform load figure, so it assumes the weight is spread along the bracket rather than hung at one point at the free end. For pipe runs, conduit racks, or equipment supports, size the run so each bracket stays within that rating and the load sits across the channel.

The B409-14ZN measures 14 in length, 4.62 in height, and 1.62 in width. The 14 inch dimension is the channel run, which is what determines how far out from the mounting surface you can land conduit or pipe clamps. It weighs 2.74 lb, so a single installer can set it without help.

It is steel with an electro-plated zinc finish, which is a dry, indoor-duty coating. It holds up fine in conditioned mechanical rooms, electrical rooms, and covered interior spaces. For exterior walls, roof decks, parking structures, wash-down areas, or coastal sites, specify a hot-dip galvanized or stainless strut bracket instead, because electro-plated zinc will rust out in those conditions.

Yes. The bracket's channel is 1.62 in wide, which is the standard 1-5/8 in strut profile, so ordinary 1-5/8 channel nuts, conduit clamps, pipe straps, and beam clamps drop straight into it. If your building is already standardized on 1-5/8 strut hardware, this bracket uses the same accessories, no separate stock needed.

A single channel bracket like the B409-14ZN is a one-piece cantilever arm that bolts to a wall, column, or strut column and gives you a length of channel sticking out to hang things from. Electricians use it to rack conduit runs off a wall, mount boxes, panels, and small gear, and support light mechanical piping. It replaces cutting and welding a bracket on site: strut nuts and clamps slide into the channel anywhere along the 14 inch arm, so spacing can be adjusted after it is hung.

No. The B409-14ZN ships as the bracket alone. You supply the anchors or through-bolts for the mounting surface, plus the channel nuts, clamps, or straps for whatever you are hanging off the arm. Pick anchors rated for your substrate with the 800 lb uniform load in mind, since the anchorage, not the bracket, is usually the weak link on a block or drywall-over-stud wall.

B409-14ZN is the manufacturer part number, from Eaton's B-Line series of strut fittings and accessories. The B409 is the single channel bracket family, the 14 is the 14 inch length, and the ZN suffix indicates the electro-plated zinc finish. Order by that full string if you need the zinc version at that length.