B-Line Eaton series wireway, 10" height, 60" length, 10" width, HSNK wireway, Thru holes, No knockouts, Hinged cover, 1, Steel, Hinged, ANSI 61 gray,

It's a 10 inch by 10 inch cross section running 60 inches long, so you get a full 100 square inches of gutter area to pull through. That's the large end of lay-in wireway, used where a 4 x 4 or 6 x 6 trough would be crowded by feeder-size conductors or a heavy bundle of branch circuits at a panel gutter.

No. The 101060 HSNK is a NEMA 1 enclosure, which is indoor general purpose only. It keeps personnel out of live parts and blocks falling dirt, but it does not seal against rain, washdown, or hosedown. For an exterior wall, a rooftop run, or a wet process area you need a NEMA 3R or NEMA 4 gasketed wireway instead.

It does not. The 101060 HSNK ships with no knockouts, so every conduit entry has to be field punched or hole sawed where you want it. That is usually what an electrician wants on a large trough, since it lets you land conduits on your own layout, but budget the punch time and the right size punches for the 14 gauge steel.

The cover is hinged, so it swings open rather than lifting off entirely, and it is secured to the body with plated screws. You back the screws out, swing it open, and the cover stays captive on the hinge instead of hanging from your free hand on a ladder. That is the practical reason to buy a hinged trough over a screw cover version on a run at height or above a panel line.

It is built to CSA C22.2, the Canadian standard for this class of electrical enclosure, so it is acceptable for Canadian installations as well as US work. That matters on cross border projects and for institutional specs that call out CSA alongside the NEMA type.

Order catalog number 101060 HSNK from Eaton B-Line. The number reads directly: 10 inch height, 10 inch width, 60 inch length, HSNK for the hinged, no knockout screw cover trough. Fittings such as elbows, tees, end plates, and connector kits are separate line items and are not included with the straight section.

Steel, 14 gauge, finished in ANSI 61 gray. That is the standard light gray used across industrial switchgear and panelboards, so a run of this trough will match existing gear in most plants and electrical rooms without repainting. The 14 gauge body is heavier wall than the light gauge troughs used on small 4 x 4 runs.

Yes, that is the normal use for a 10 x 10 gutter. With 100 square inches of cross section and a hinged cover you can pull, splice, and tap inside it, and the blank sides let you place conduit entries wherever the pull geometry needs them. Keep splices and taps within the fill limits your inspector applies to auxiliary gutters.