B-Line Eaton series wiring trough, 10" height, 24" length, 10" width, HS wireway, Thru holes, Hinged cover, 1, Steel, Hinged, ANSI 61 gray, 14 gauge

It is a 10 x 10 inch cross section, 24 inches long. That 10 by 10 opening is what determines how much conductor fill you can run and whether your conduit hubs and connectors land cleanly on the sides. Body and cover are 14 gauge steel and the assembly weighs 17.305 lb, so one person can hang a section without a lift.

No. The 101024 HS is a NEMA 1 enclosure, which is indoor, dry location only, for protection against incidental contact and falling dirt. If the run goes outside, into a washdown area, or anywhere subject to rain or hose spray, you need a NEMA 3R or 4 rated trough instead, not this one.

HS is the hinged screw cover style. The cover swings open on a hinge so you can lay in conductors with both hands instead of juggling a loose lid, and then it is secured to the body with plated screws. A standard screw cover trough requires you to fully remove the cover every time you open it, which is why HS is the usual pick on runs that get re-entered for changes or troubleshooting.

It mounts through holes in the enclosure back, so you fasten it directly to the surface or to strut with your own hardware. Mounting fasteners and any strut, brackets, or standoffs are supplied by the installer. Plan your anchor spacing around the 24 inch section length and the 17.305 lb weight of each empty section, before conductor fill is added.

Yes, the 101024 HS is certified to CSA C22.2, which is what an inspector north of the border will be looking for on a wireway. That keeps it usable on Canadian commercial and institutional work as well as US jobs.

Wireway is built to be coupled section to section, so multiple 24 inch lengths of the same 10 x 10 body line up flange to flange to make the run length you need. Connectors, closing plates, elbows, and end caps are separate items and are not part of the trough itself, so order those alongside the sections.

Specify Eaton B-Line part number 101024 HS. The number reads as the dimensions: 10 inch height, 10 inch width, 24 inch length, with HS for the hinged screw cover.

The finish is ANSI 61 gray, the standard gray used across most commercial electrical gear, so it lines up with typical panelboard, switchboard, and disconnect finishes in the same building. If your existing equipment is a custom color or a light gray other than ANSI 61, the section will read slightly different.

14 gauge is the heavier of the common wireway body thicknesses and holds its shape on longer horizontal runs between supports, which matters on a 10 by 10 cross section carrying a full conductor bundle. Thinner-gauge troughs are more prone to oil-canning on the cover and distorting at the flange when you bolt sections together.