B-Line Eaton series wiring trough, 4" height, 72" length, 4" width, G wireway, Thru holes, 23 top knockouts, 23 bottom knockouts, Screw cover, 1, Ste

No. The 4472 G is a NEMA 1 enclosure, which is indoor general purpose only, with no gasketing against water. For outdoor, washdown, or damp locations you need a NEMA 3R or 4 rated trough instead. The screw cover on this one seats with plated screws, not a gasket.

Mounting is through holes in the body, so it fastens directly to a wall, strut, or backpan with your own fasteners sized to the substrate. No mounting brackets or anchors are part of the trough, and the fasteners supplied with it are the plated screws for the cover.

It ships with 23 knockouts on the top and 23 on the bottom, so conduit entries down the length of the run are already provided. That spacing suits repeated drops into a row of panels or disconnects; you only need to punch if you want an entry the factory pattern does not give you.

The 4472 G uses a screw-on cover held by plated screws. That is what you want on a run that gets wired once and rarely opened, because the cover clamps down tight along its whole length. If you expect to be back in the trough regularly for changes or troubleshooting, a hinged or quick-release cover wireway saves time, since a 72 inch screw cover means backing out every screw before you can get in.

The 4472 G is CSA Certified, so it is acceptable for Canadian installations as well as US work. Cite part number 4472 G on the submittal.

The finish is ANSI 61 gray, the standard gray used on most switchgear, panelboards, and industrial control enclosures, so it lines up visually with existing gear in a typical electrical room or plant floor.