Emtek 1335 Multi Point Lock Trim (Door Config #3) - Lost Wax Cast Bronze Plates, Tuscany Style (1.5" x 11-1/8"), Dummy Pair

No. The 1335 is trim only: plates and handles for a swinging patio door. The multi point mortise lock box is not included, and because this is the dummy pair version there is no working latch or keyed cylinder in it at all. If you need the operating hardware, order the multi point mortise lock separately.

It is non-operating hardware. A dummy pair mounts handles and plates on both faces of a door leaf for pull and appearance only, with no latch, no cylinder and no multi point engagement. It is what you use on the inactive leaf of a French door pair, or on a fixed panel, so it matches the active door that carries the real multi point lock.

It covers doors from 1-3/8 to 1-3/4 inches, which spans standard residential patio and entry leaf thicknesses. Mounting is surface mount with no door prep required, so you are not boring or routing the leaf to install it. There is a door thickness field on the order so you can state the exact leaf you are working with.

Emtek groups its multi point trim by door configuration, which describes where the cylinder and handle sit relative to each other on the plate. The 1335 is configuration #3: cylinder above the handle, with 4-1/8 inch center-to-center between the cylinder and the lever spindle, and an American style cylinder opening. Measure that cylinder-to-handle dimension on your existing plate or on the multi point lock you are pairing it with. If it is not 4-1/8 inches, you need a different Emtek configuration.

Andersen is the referenced door manufacturer for the 1335 trim, so it is built around that hardware layout. Confirm your door's cylinder-above-handle arrangement and 4-1/8 inch center-to-center spacing match before ordering, since Andersen multi point doors are not all prepped the same way.

Yes, handing is required. You choose right hand (RH) or left hand (LH) so the lever throw and plate orientation match the leaf. Get it wrong and the lever points the wrong way against the jamb, so establish the handing from outside the door before you order.

For a locking leaf, yes, this is the wrong item. The 1335 is a dummy pair with no keyed cylinder and no lock box, so it cannot secure the door. Order the keyed or active multi point trim in the same Tuscany bronze configuration #3 layout, along with the multi point mortise lock, and use the 1335 only on the inactive or fixed leaf so both doors look the same.

Three choices, plus an optional one. Finish comes in Flat Black Bronze (FB) or Medium Bronze (MB). Lever style is required and offered as Medici (MD), Napoli (NA), Octagon (OCL) or Padua (PD). Handing is required, right or left. You can also enter your door thickness. The plates measure 1-1/2 by 11-1/8 inches.

Any Emtek Lost Wax Cast Bronze lever from the Tuscany bronze range can be ordered with these plates, and the four offered on the trim are Medici, Napoli, Octagon and Padua. Staying inside the Tuscany Bronze collection is what keeps the casting texture and finish consistent between lever and plate.

It is classified residential. The plates are lost wax cast bronze in Emtek's Tuscany style, intended for swinging patio and French doors in homes and high-end multi-family rather than for commercial traffic openings. For a commercial entrance you want a Grade 1 rated commercial lockset instead.